DTW-based-on-0~9

三维射流网格、速度剖面坐标变换显示、基于matlab 的图形显示。 (to show the velocity profile and its grid.)

模型降阶的资料，十分新颖，主要是非线性系统(Model reduction for nonlinear DAEs)

说明：  根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)

有关血压算法的算法实现，分别用C语言和Matlab语言(you guan xueya suanfa de suanfa shixian ,fen bie yong C and Matlab)

基于快速S变换的配电网故障选线，比传统的S变换计算速度快(Fault Line Selection in Distribution Networks S Transform)

shooting 打靶法，MATLAB编程，仅供参考。(shooting shooting method, MATLAB programming, for reference only.)

Nonuniform mesh semivector: Illustrates usage of the semivector modesolver to calculate the quasi-TE and quasi-TM modes of a ridge waveguide. Use the stretchmesh function to expand the size of the computation window at the edges without increasing the number of gridpoints.

地震资料中对所接受到的数据进行动校正的演示程序(Seismic data in the received data for dynamic correction of the demonstration program)

根据能谱的定义来计算能谱的程序，内涵fortran程序(power spectral)

HHT精华讨论，对运用ＨＨＴ进行数据分析时遇到的问题有详细的解答，是学习ＨＨＴ不可或缺的资料(HHT essence discussion, this paper analyzed the data using HHT is there detailed solution to the problems encountered in the process of, is indispensable to study HHT data)