Source-Code

单片机M8电子负载，包括原理图，源程序；可以参考学习一下(MCU M8 electronic load, including schematics, source code can refer to learn about)

关于电子设计大赛的样板，可以作为起始工程文件(temple,this is a temple for design)

针对RN8209新型电表计量芯片的校表软件，使用DLT645-2007通讯协议(RN8209 for new electricity metering chip calibration software, communications protocols using DLT645-2007)

用8051单片机来驱动的2.0吋TFT屏（S6D0118的IC）(use 8051 to drive the 2.0-inch TFT screen (S6D0118 IC))

《现代电机控制技术》王成元主编的一本很好的关于电机控制的书，详细的讲解了异步电机，同步电机矢量控制直接转矩控制等。(a good book on motor control edited by wangchengyuan)

本作品可实现如下功能： 1. 显示年、月、日、星期等日期项 2. 显示时、分、秒等时间项 3. 测量并显示温度 4. 秒表（含开始，暂停，继续，复位等） 5. 闹钟（含开关，时间设定，是否启用的标志等，精确到秒） 6. 时间和日期的校正（加减均可） (The works can achieve the following functions: 1 year, month, date, day of the week, the date of entry. Displayed, minutes, seconds time of 3 to measure and display the temperature. The stopwatch (including start, pause, resume, reset etc. ) 5 alarm (including switch, time set, the flag is enabled, accurate to seconds) the time and date of the correction (addition and subtraction can be))

光照传感器BH1750FVI在lcd显示(Light sensor is displayed in the lcd)

说明：  基于STM32的触摸屏实验。使用TFT液晶屏。(Touch Screen Experiment Based on STM32)

本程序采用kiel开发，使用DS1302作为时钟源，八位数码管进行动态扫描显示时间，并可以由上位机发送“R/r”（read）命令由单片机发送时间和日期信息到上位机(The program uses kiel development, use DS1302 as the clock source, eight digital tube dynamic scan display time, and can be sent from the host computer " R/r" (read) command from the microcontroller to send the time and date information to the host computer)

说明：  led闪烁简单的c51入门程序代码，适合初学者入门的程序代码(LED flashes a simple entry procedures C51 code Suitable for beginners entry code )