登录
首页 » matlab » rayleigh-chan

rayleigh-chan

于 2013-09-21 发布 文件大小:18KB
0 214
下载积分: 1 下载次数: 16

代码说明:

  程序仿真了瑞利信道,分析和大量实测表明,多径效应使接收信号包络变化接近瑞利分布。在典型移动通信中,衰落深度达30dB左右,衰落速率约30~40次/秒。(Rayleigh channel simulation procedures, analysis and extensive test shows that the received signal multipath effect changes in the envelope close to the Rayleigh distribution. In a typical mobile communication, fading depth of about 30dB, the decline rate of about 30 to 40 times/sec.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 12
    说明:  最大信噪比盲源分离算法 该算法参考文为 给予最大信噪比的盲源分离算法 《计算机仿真》 2006.2(Maximum signal to noise ratio Blind source separation)
    2011-05-09 16:46:16下载
    积分:1
  • ecgsimple
    关于心电图入门的基本知识,便于初学者学习和使用。(Getting Started on the basic knowledge of ECG, easy for beginners to learn and use.)
    2008-03-16 22:25:14下载
    积分:1
  • Shannon
    随机产生一个信源概率空间,并对其进行香农编码,输出码长和编码(shannon coding)
    2014-12-22 21:01:05下载
    积分:1
  • CreatehfssVBS
    射频滤波器 利用综合优化后产生的耦合矩阵 生成在hfss中自动建模的脚本文件 (The coupling matrix is produced using the optimized integrated RF filters are generated in the HFSS script file automatically modeling)
    2020-10-19 22:27:26下载
    积分:1
  • PN_sequences1_final
    说明:  PN code generation for any length of generator polynomial
    2020-10-09 16:47:36下载
    积分:1
  • encdecm
    This code simulates Distance Vector Routing protocol used for routing in communication networks
    2011-02-01 21:41:39下载
    积分:1
  • kse_test_matlab
    Given a matrix with m rows and n cols (m points in R^n), use resampling and the Kolmogorov Smirnov test to score [0,1] all points (as potential outliers) in linear time. This is an original algorithm that can be used for anomaly detection and general signal processing.
    2013-05-26 22:10:16下载
    积分:1
  • fuzzy-logic-project
    CI fuzzy logic application on aircraft landing program
    2013-02-12 10:12:52下载
    积分:1
  • demo2
    This is the demo file for L1 adaptive controller with unknown parameter, unknown disturbance, unknown control effectiveness: dot x(t) = Ax(t) + b(omega u(t) + heta(t)^ op x(t) + sigma(t)) DoSims.m: This script initializes the model parameters, run the simulation. You can split the parts you need and do the simulations according to your interest. L1Model_sec2.mdl:the implementation of the system. Refer to the following paper for background: C. Cao, and N. Hovakimyan, “L1 adaptive controller for systems with unknown time-varying parameters and disturbances in the presence of non-zero trajectory initialization error”, International Journal of Control, Vol. 81, No. 7, 1147–1161, July 2008
    2012-08-27 05:05:45下载
    积分:1
  • 1231
    MATLAB 图像处理命令,在二进制图像中利用 lookup 表进行边沿操作(MATLAB image processing orders, in a binary image using the lookup table by using the edge operator )
    2013-04-30 00:37:32下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载