upper-computer

labview vi程序，基于版本8.2可以直接运行，,用来仿真电容充放电过程(labview vi program, based on version 8.2 can be run directly, to simulate capacitor charging and discharging process)

MATLAB编写无穷大电源发生三相短路的程序，已通过编译，有仿真结果(Infinite power happens three phase short circuit)

Labview数据采集编程指南，介绍采集系统的组成及NI的一些硬件。(The manual of DAQ with labview ,including the components of a DAQ system.)

可以通过labview进行USB通讯，凄凄切切群群群群群群群群群(USB communication through LabVIEW)

基于LabVIEW软件编写，利用二维卷积实现图像边缘检测。(Written based on LabVIEW software, the use of two-dimensional convolution image edge detection.)

信号发生器，带扫频，带频率的切换！最小可以0.1HZ。(Frequency sweep signal generator, belt, belt frequency switch! Minimum to 0.1 HZ.)

说明：  用labview做了一个火车故障检测系统，靠软件仿真(Labview is used to make a train fault detection system, by software simulation)

一个Labview2009 安装及破解过程的文件，包括安装程序，注册机和破解步骤(Labview aviode overtime)

二代小波包分析，能够将选择的文件进行二代小波分解，分解层数为5层(Wavelet packet analysis)

说明：  使用usrp n210,利用Labview实现正弦信号收发，一方面可以利用labview实现实际信号在空中收发，另一方面可以检验设备正常运行。(Using USRP N210 and Labview to transmit and receive sinusoidal signals, on the one hand, it can use LabVIEW to transmit and receive actual signals in the air, on the other hand, it can check the normal operation of the equipment.)