LTE-MIMO

implement of IFSAR using matlab (implement of IFSAR using matlab)

Stop-and-wait ARQ is a method used in telecommunications to send information between two connected devices. It ensures that information is not lost due to dropped packets and that packets are received in the correct order. It is the simplest kind of automatic repeat-request (ARQ) method. A stop-and-wait ARQ sender sends one frame at a time it is a special case of the general sliding window protocol with both transmit and receive window sizes equal to 1. After sending each frame, the sender doesn t send any further frames until it receives an acknowledgement (ACK) signal. After receiving a good frame, the receiver sends an ACK. If the ACK does not reach the sender before a certain time, known as the timeout, the sender sends the same frame again.

Adaptive Control: Introduction Overview, and Applications

ADVANCED MOUSE POINTER CONTROL USING TRAJECTORY

在matlab下运行，产生标准均匀分布，正态分布和指数分布的随机数发生器程序。(In matlab running, generate standard uniform, normal and exponential distribution random number generator program.)

PI仿真simulink的模糊控制，基于simulink和设计的模糊控制块设定的闭环pid控制(Simulink simulation of fuzzy control PI)

single phase 11 level inverter

A simple router modeled in MATLAB s Stateflow. Can be simulated and linked to analyze traffic flow and communication.

16QAM Vblast 误码率仿真(16QAM Vblast BER simulation)

说明：  OFDM在AWGN信道下的仿真，用MATLAB实现，一共有6个程序。(OFDM AWGN under the simulation, using MATLAB, a total of six procedures.)