-
FFT_all
用Matlab产生正弦波,矩形波,以及白噪声信号,并显示各自时域波形图
进行FFT变换,显示各自频谱图,其中采样率,频率、数据长度自选
做出上述三种信号的均方根图谱,功率图谱,以及对数均方根图谱
用IFFT傅立叶反变换恢复信号,并显示恢复的正弦信号时域波形图(fft analysis,plot rms spectrum,power density spectrum, etc.)
- 2019-05-12 10:03:40下载
- 积分:1
-
qpsk
Program for Linear block code
- 2011-01-24 23:11:55下载
- 积分:1
-
CarSim与Simulink联合仿真.rar
基于matlab 和carsim的联合仿真教程,欢迎下载学习,
中文版(Based on MATLAB and CarSim co simulation course, welcome to download learning.
Chinese version)
- 2018-06-21 22:27:00下载
- 积分:1
-
codeInBlogs-master
基于rssi射线模型的室内定位算法,卡尔曼滤波(indoor positioning algorithm,Kalman filter)
- 2017-04-21 10:25:27下载
- 积分:1
-
echopursuit
智能车控制,预瞄追踪,实车验证,参加过比赛。好用好用好用(Intelligent vehicle control, preview tracking, real vehicle verification, participated in the competition. Good use, good use and good use.)
- 2018-11-17 20:52:44下载
- 积分:1
-
PolCalQuegan
极化SAR定标处理matlab程序,采用Quegan算法(Polarization SAR processing matlab calibration procedures, the use of Quegan algorithm)
- 2010-11-01 13:03:32下载
- 积分:1
-
THE_FAST_HANDOVER_RESEARCH_of_wimax_network
说明: 本文正是在研究WIMAX/802.16e协议和FMIPv6协议的基础之
上,提出了基于FMIPv6的WIMAX网络快速切换机制,该方案采用跨
层切换的思想,MAC层联合网络层同时进行切换,在链路尚未断开
之前即完成新转交地址(NCOA)获取等功能,从而加快了切换进程,
减小了切换时延和切换时的丢包率。在提出本切换机制的基础上,本
文在NSZ仿真平台上对所提出的切换方案做了系统性的性能仿真,通
过仿真结果验证了方案的可行性和优越性。
( In this paper, IEEE802.16e standard is described at first. Then an
introduction for the basic knowledge and research in MIPv6 and FMIPv6
protocol is given. A fast handover scheme of WiMAX network which
based on FMIPv6 protocol is suggested, which implements the fast
handover at IP layer associating with MAC layer at the same time.
scheme minimizes handover latency by predicting and preparing
This
the
impending handover in advance. Finally, simulation are carried out to
evaluate the performance of this fast handover scheme. The result of the
simulation shows that the fast handover scheme has good performance.
)
- 2010-04-28 09:22:20下载
- 积分:1
-
maximum-likelihood-estimation-method-can-be-used-
maximum likelihood estimation method can be used to very broad estimation
- 2015-02-16 10:08:18下载
- 积分:1
-
mohupid
基于matlab模糊pid的仿真,主要应用于工业控制方面。(fiizzy pid control)
- 2012-06-02 20:53:32下载
- 积分:1
-
MATLAB
用matlab来做一个三维模型,包括两个部分: 1.长方体 2.很多个半径(远小于长方体边)很小的球体随机分布在长方体中。(Using MATLAB to make a three-dimensional model, including two parts: 1. a rectangular cube with a lot of radius (which is far smaller than the side of a rectangular body) and a small sphere is randomly distributed in a rectangular body.)
- 2020-11-24 21:29:34下载
- 积分:1