fixed-point

利用随机共振原理检测弱信号。a_b_f.m为主程序(Use of the principle of stochastic resonance detection of weak signal. a_b_f.m-based procedures)

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)

Sparsity-Promoting Optimal Wide-Area Control of Power Networks

两通道fxlms降噪matlab仿真亲测能用(Fxlms two-channel noise reduction can be pro-test simulation matlab)

基于加权最小二乘辨识的自适应极点配置算法(adaptive control based on system identification & pole-placement)

不错的在机械工程中应用的源程序，根据转轴等参数计算时长等一系列数值(Good in mechanical engineering applications, source code, according to parameters such as shaft length and a series of numerical calculations)

基于simulink的SVPWM仿真，自己编写的，最后还差一个三相桥，大家可自行加上(Based on SVPWM simulation simulink, I have written, and finally a three-phase bridge worse, we can add their own)

无线通信中MIMO信道容量OFDM信道防真，BPSK调制(MIMO wireless communication OFDM modulation channel capacity to prevent)

Provas termeletrica, engenharia eletrica brasil!

快速傅里叶变换的matlab实现，用于对信号进行频谱分析(Fast Fourier transform matlab implementation for spectral analysis of signals)