hamming_QPSK

Matlab单队列多服务台仿真总流程图 本系统仿真程序采用事件步长法进行仿真，由以下功能模块组成： 1、仿真时钟； 2、事件表； 3、系统状态变量； 4、初始化子程序； 5、事件子程序； 6、调度子程序； 7、时钟推进子程序； 8、随机数产生子程序； 9、输出函数子程序； 10、统计计数器； 11、主程序。(Matlab simulation of the total single-queue multi-desk system simulation program flow chart of the step method used to simulate the event by the following functional modules: 1, simulation clock 2, the event table 3, the system state variables 4, the initialization sub- procedures 5, event subroutine 6, the scheduling routine 7, the clock forward subroutine 8, random number generation routine 9, the output function routine 10, statistical counters 11, the main program.)

hspice toolbox with matlab.

曲线回归分析：直线回归、双对数回归、半对数回归、倒数回归(Curvilinear regression analysis: linear regression, double logarithmic regression, semi-logarithmic regression, countdown)

说明：  一些入门的并网控制系统，含光伏和储能部分。(Some introductory networked control systems, including photovoltaic and energy storage)

说明：  This matlab codes calculates the mutual information and the conditional mutual information based on k-nearest neighbor algorithm.

其他网站是找的svpwm滑膜控制整流，但我感觉就是一般矢量控制整流，版本是matlab7.1，想让大家看看，看有明白的帮忙告诉我下设置方式。运行前参数设置Ts_Power=100e-6 Ts_Control=100e-6 (Other sites are looking for svpwm synovial controlled rectifier, but I feel that the general vector control rectifier, the version is matlab7.1, let us take a look to see if there is a clear help to tell my next set up. Parameter settings before running Ts_Power = 100e-6 Ts_Control = 100e-6 )

simulink中建立的汽车转向自动回正模型(simulink automotive steering automatically created back to being model)

滑模控制系统的设计建立 多输入多输出非线性系统的线性化程序(Sliding mode control systems design and a multi-input multi-output linearization of nonlinear systems program)

Antenne parabolique alimentée par guide d onde

C-C法求混沌系统的延迟时间，该程序是C-C法的函数文件，已测试，可运行多种数据，运行时间快(The C-C method seeks the delay time of the chaotic system. The program is a function file of C-C method. It has been tested and can run many kinds of data.)