matlab-modeling-algorithm(2)

说明：  一篇关于异步电机滑模变结构直接转矩控制的硕士论文(a paper of induction motor based on sliding mode DTC )

使用matlab读取大量实验数据，并进行计算和分析的程序(Using matlab to read large amounts of experimental data and calculations and analysis procedures)

说明：  通过MATLAB仿真软件,建立风力发电系统控制模型以及完整的风力发电样例系统模型.(Through the MATLAB simulation software, the wind power system control model and the complete wind power sample system model are established.)

MATLAB教程.CHM2.9M.chm(MATLAB Tutorial. CHM2.9M.chm)

说明：  在X，y方向分别放水平磁环，在Z轴上放电偶极子，给出信号方位角估计随极化角度和俯仰角的变化的估计性能(In X, y directions are the level of magnetic release, discharge in the Z-axis dipole is given with the polarization angle estimate signal azimuth and elevation changes in the estimation performance)

psat2.1.2说明文档，用于学习past，稳态暂态潮流计算以及故障分析(psat2.1.2 documentation, for learning past, steady-state flow calculation and fault analysis of transient)

自己编写的自适应控制程序，包括代码和simulink仿真模型。(His writing the adaptive control program, including code and simulink model. )

数值积分方法计算积分方程，利用复化辛普森公式离散积分项(Integral equation numerical integration method, the use of complex discrete integral term of Simpson formula)

已知高程的水准点和待定点，观测高差和相应的水准路线长度，间接平差求各待定点的高程平差值； (Known elevation level point and pending points observed height difference and the corresponding level of route length, indirectly the elevation level difference between the adjustment and the pending points )

DTF - equation implementation(DTF- equation implementation)