main

介绍经验模态分解的emd算法上下包络线的形成过程(Introduction emd empirical mode decomposition algorithm for the upper and lower envelope formation)

单级倒立摆LQR控制，通过LQR控制，为了使系统具有快速的响应，对Q矩阵中的参数Q11和Q33进行调整。(Linear Quadratic Regulator——LQR，adjust the parameter of the Q，fasting the response rate)

基于广义逆的最小二乘曲线拟合，采用满秩分解，用其中一个就可以了，单个太小，不让上传，所以复制三份(curve fitting by using generalized inverse matrix )

傅里叶变换，用于故障诊断时候的频谱分析，压缩文件中包含一个word文档，用于分析电机故障中的电流中的噪声频谱。(FFT is commonly used to analyse fault diagnosis, especially when dealing with machine faults)

线性二自由度车辆操纵模型分析与建立，利用simulink搭建线性二自由度车辆操纵模型。(Analysis and establishment of vehicle handling model with linear two degrees of freedom)

gram-schimdt-orthogonalization matlab pro

详细讲解信号处理的pdf,里面包含了FFT，小波，希尔伯特-黄变换等内容，是信号处理方面很好的参考资料(Explain in detail the signal processing pdf, which contains the FFT, wavelet, Hilbert- Huang Transform, etc., is a good reference for signal processing, data)

This Program is Simulink for the characterstics idetification of the designed Solar Cell Models

Design a fuzzy system to approximate a function the function may not be defined analytically but the values of the function in n point is defined for example : x E [-3 3] g(x)=sin(x) the approximation is calculated a fuzzy set design our fuzzy function approximates sin function with an error less than 0.2 note : this program uses a function named isinrange so copy it to your directory

WIMAX which used simulation for performance analysis