1118-daidiaoyong

在这项研究工作中主要集中开发基于混合光伏风电系统的智能控制和电网整合以及电池存储系统。电网整合混合式PV-Wind与基于智能控制器的电池管理系统[BMS]已经在Matlab中开发了一个仿真模型，并分析了正常条件下的系统性能。同样的系统已经用UPFC模拟，并分析了不同故障条件下的系统性能。(In this research work focused on the development of smart grid integration and control, and battery storage system based on photovoltaic hybrid wind systems. Grid integration hybrid PV-Wind-based intelligent controller and a battery management system [BMS] has developed a simulation model in Matlab and analyze system performance under normal conditions. The same system has been used UPFC simulation, and analysis of the performance of the system under various fault conditions.)

说明：  设计了燃料电池的分布式发电系统，将分布式发电系统与电网进行并联。并对其进行了仿真。(Has designed fuel cell s distributional generating system, carries on parallel the distributional generating system and the electrical network. And has carried on the simulation to it. )

说明：  电力电子基础内容，整流部分的单相半波整流电路(single-phase half-wave)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

hvdc sysytem with six igbt

在matlab平台上的风力机组建模和仿真的一个demo(Modeling and Simulation of wind turbine in matlab platform of a demo)

mathematical model of wind Turbine

光伏最大功率跟踪控制仿真，实现光伏最大功率运行(Photovoltaic maximum power tracking control simulation to achieve maximum power operation of photovoltaic)

电力IEC61850标准的SCL_schema文件。(Power IEC61850 standard SCL_schema files. )

说明：  利用ATP/EMTP计算高燕架空输电线路感应电压、电流计算模型(Calculation Model of Induced Voltage and Current of Gaoyan Overhead Transmission Line by ATP/EMTP)