dip_proj2

此为雷达对抗的基本知识.对初始学习的人有一定的帮助.(This is the basic knowledge of radar confrontation. For the initial study were certainly helpful to them.)

***************CPM modulation***************** 关联长度为L=3 连续相位调制 by yyf 2010.11.12 ***************CPM modulation*****************( ***************CPM modulation***************** 关联长度为L=3 连续相位调制 by yyf 2010.11.12 ***************CPM modulation*****************)

  最小费用最大流算法通用Matlab函数 基于Floyd最短路算法的Ford和Fulkerson迭加算法   基本思路：把各条弧上单位流量的费用看成某种长度,用Floyd求最短路的方法确定一条   自V1至Vn的最短路 再将这条最短路作为可扩充路,用求解最大流问题的方法将其上的流   量增至最大可能值 而这条最短路上的流量增加后,其上各条弧的单位流量的费用要重新   确定,如此多次迭代,最终得到最小费用最大流.( Minimum cost maximum flow algorithm for general Matlab functions based on the Floyd shortest path algorithm of Ford and Fulkerson superposition algorithm of the basic ideas: the cost of unit flow on the arc as a certain length of Floyd for the most short-circuit method to determine the one percent V1 through Vn are the most short-circuit then this short circuit as a scalable road, a method for solving the maximum flow problem on flow increased to the maximum possible value that the shortest way increased traffic, the cost of unit flow on each arc sure, so many iterations, the final minimum cost maximum flow.)

steepest descent method

FDTD方法的书，书中有代码，很不错，可以看看(FDTD)

可用于声纳、雷达信号处理的波束形成程序，利用相移法对多信源目标进行方位估计。(Can be used for sonar, radar signal processing beamforming procedure, and use the phase shift method for multi-source target position is estimated.)

Floyd算法适用于APSP(All Pairs Shortest Paths)，(APSP(All Pairs Shortest Paths)，)

多传感器数据融合：将MATLAB语言应用到多传感器数据融合中，书中给出了大量的仿真实例(multisensor Data Fusion with matlab)

matlab仿真出刀刃的夫琅禾费衍射，其中有四副图，原图，二维衍射图样，函数图象和三维衍射图样(matlab simulation of the cutting edge of the Fraunhofer diffraction, which has four maps, original, two-dimensional diffraction patterns, functions, images and three-dimensional diffraction pattern)

BPSK调制解调，通过插入导引进行信道估计的最简单simulink建模(the channel estimation)