Genetic-Algorithms-matlab

This code run in matlab and it is the iterative SOCP

对HARQ系统的吞吐量分析，isodata 迭代自组织的数据分析，可实现对二维数据的聚类。( HARQ throughput analysis of the system, Isodata iterative self-organizing data analysis, Can realize the two-dimensional data clustering.)

uses to statistically bootstrap the values

基于坐标变换的三相交流异步电机模型，采用maltab/simulink建立的模型，三相交流电压型输入。(Motor model based on coordinate transformation maltab/simulink established model, three-phase AC voltage input.)

chapter 1 of the fdtd method for electromagnetics with matlab simulations

说明：  使用“旋轮法正比选择”、“单切点交叉”和单点突变的遗传算法(Use &quot proportional to select the roller method,&quot &quot single-cut point crossover&quot and the single point mutation in the genetic algorithm)

This program is used for feature detection using corner and edge detection

面接触滑块润滑基于有限差分法，用于求解面接触滑块润滑的油膜厚度、油膜压力等(Lubricating surface contact with the slider based on the finite difference method for solving the contact surface of the slider lubrication film thickness, film stress, etc.)

说明：  结构可靠性分析中的重要度抽样、蒙特卡洛仿真方法(importance sampling technique and Monte Carlo simulation in system structural reliability analysis)

十进制遗传算法matlab程序,该程序主要实现十进制下的遗传算法.(Decimal genetic algorithm matlab program, the program is primarily to achieve the decimal under the genetic algorithm.)