PIDControl

UWB，超宽带信号分析必用的子函数，第8部分！(UWB, ultra-wideband signal analysis will be used for Functions, Part 8!)

源代码中是三个子程序，分别为R,RRR,RRP,用于分析机构的各部分的速度，加速度，坐标。R用于分析原动杆，RRR用于分析双杆组构件，RRP用于分析两转动副一滑动副的双杆组。分析一个具体机构时可先将机构拆成原动杆和各杆组，然后调用这三个子程序来计算。(Source code of three subroutines, namely R, RRR, RRP, for the analysis of body parts of the velocity, acceleration, coordinates. R for the analysis of the original rod, RRR for the analysis of double-pole group member, RRP for the analysis of two revolute a sliding two-bar group vice. Analysis of a sector specific institutions can be split into the original first rod and the bar group, and then call subroutine to calculate the three.)

The Phantom of instantaneous

对实现通过matlab进行图像处理的操作有一定的帮助与借鉴意义。(matlab image processing)

Windows下的ICMP封装(Clcmp class which can echo)

match filter simulation program

WIRELESS OFDM TECHNIQUE USING SIMULINK

实现用LMS算法进行自适应滤波的仿真，基于GUI实现(Implementation using LMS algorithm for the simulation of adaptive filter, based on the GUI implementation )

Gaussian3D Creates 3-D Gaussian Kernel of specified width sigma_array=[sigma_x, sigma_y, sigma_z]

通过并行压缩进行二维信号压缩，提出了一种利用并行压缩传感技术对二维信号进行压缩的新方案。根据这个原理，译码器的重新构造可以并行进行。通过对二维信号进行某些排列，可以确保所有列具有大致相同的密度级别，并且可以使用相同的测量矩阵进行采样。这样可以避免二维信号的矢量化，从而大大减小测量矩阵的尺寸。我们证明，如果排列良好，重建均方误差的上限会更紧。为了说明这一方案，我们将其应用于视频压缩并使用不同帧的排列有两种：参考帧的基于Z字形扫描的排列和非参考帧的基于块测试的排列。仿真结果表明，在相同的压缩比下，峰值信噪比比比在无置换情况下可提高3-7db左右。(we propose a new scheme to compress 2D signals using parallel compressed sensing. According to this seheme, the reeonstruction at the decoder can be performed in parallel. By performing certain permutation on a 2D signal, all columns are insured to have approximately the same density level and can be sampled using the same measurement matrix. In this way, vectorization of a 2D signal can be avoided, and thus the size of the measurement matrix can be dramatically reduced. We prove that with a good permutation, we can have a tighter upper bound on reconstruction mean square error. To illustrate this scheme, we apply it to video compression and use two kinds of permutations for different frames: the zigzag-scanbased permutation for reference frames and the block-test-based permutation for non-reference frames. Simulation results show that under the same compression ratio, the peak signal-to-noise ratio can be improved by approximately 3-7 dB compared to the case without permutation.)