TPAMI_matching_demo

该程序是基于MATLAB编写的对信号进行分析的随机信号通过线性系统，包括时域、频域等多项分析(signal and system analysis)

适用于matlab学习，开发，研究，便于深入研究的学者(Matlab for learning, development, research, and to facilitate in-depth study of the scholars)

dynamic voltage restorer with 11 level diode clamp inverter

Set of tools to perform transformations between projection, ellipsoidal and cartesian coordinates in either direction. (Set of tools to perform transformations be tween projection. ellipsoidal and cartesian coordinates in eith er direction.)

说明：  计算多自由度体系振动反应分析时的威尔逊法的实现(Realization of Wilson's Method in the Analysis of Vibration Response of Multi-degree-of-freedom System)

使用Matlab仿真QAM和M=4的PSK(Matlab simulation using QAM and M = 4 of the PSK)

6N137 高速光耦隔离芯片 应用于各种需要隔离场合(6N137 optocoupler isolated high-speed chips in a variety of situations need to be isolated)

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)

模式识别MATLAB代码模式识别M模式识别MATLAB代码ATLAB代码(Pattern of all kinds of matlab algorithm )

This is a detector of RR based on wavelet for ECG os 1khz sample frequency