xds100v3r2.0

本人基于ti dsp 开发环境CCS的四旋翼程序(I am four rotor based on ti DSP development environment CCS)

本文在现有的压实度检测技术的基础上,引入高性能的专用数字信号处理器(CDSP),通过对压路机振动轴加速度信号的实时采集、分析,实现了对道路的压实度分布状态的连续、实时检测。(In this paper, the existing degree of compaction based on the detection technology, the introduction of a dedicated high-performance digital signal processor (CDSP), through the vibration of the roller axis acceleration signals in real-time collection, analysis, and achieved a degree of compaction of road distribution continuous, real-time detection.)

介绍一种简易的异步电机参数辨识方法，该方法能在电机静止状态下辨识出电机的各个参数，并在基于TMS320F2812 为主控制器的异步电机无速度传感器矢量控制系统进行实验，将辨识得到的参数投入到实际系统中。(Presented a simple induction motor parameter identification method． This method can identify the parameters of the induction motor in a stationary state． Experiment was carried out on speed sensorless vector control system based on TMS320F2812． Parameters obtained from the identification were input to the vector control system．)

CCS 64点FFT实现 用于DSP实验(CCS 64-point FFT for DSP experimental realization)

说明：  实现UDP的网络传输，在PC建立UDP的服务器，向fpga的ip：192.168.0.25发送数据，实现回环通讯。(The network transmission of UDP is realized. UDP server is set up in PC, and the data is sent to IP: 192.168.0.25 of FPGA to realize loop communication.)

步进电机的SIMLINK模型，作为步进电机的模块，对步进电机进行仿真(Stepper motor SIMLINK model, as the stepper motor module, the simulation of the stepper motor)

软启动，SVPWM，ADC采样及滤波，FOC，是根据TMS320F2833XDSO应用开发与实践的例子写的，已调试(Soft boot, SVPWM, ADC sampling and filtering, FOC, is based on the example of TMS320F2833XDSO application development and practice, and has been debugged)

DSP-BIOS Bridge driver support functions for Linux v2.13.6.

与DSP串口通信,实现串口的收发，保存，显示。是一个友好的串口调试界面(dsp,labview)

PSIM仿真1字型三电平中点箝位并网光伏逆变器，采用SPWM调制 (The the PSIM simulation 1 font tri-level neutral point clamped grid PV inverter SPWM modulation)