Matlab-Basic-and-Application

求解ppln中脉冲传输的问题 采用split step fourier method(Ppln in solving the problem of pulse transmission using split step fourier method)

说明：  运用M-file编写的永磁同步发电机的稳态运行模型，能输出电机的效率，定转子电流等曲线(Prepared using M-file the steady-state operation of permanent magnet synchronous generator model, the efficiency of the motor can output, stator and rotor currents and the curve)

杨氏双缝干涉 两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2, 满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ, 最后可得公式如下： ， 最后光强I=4I0cos2（Φ/2）。 观察相干光叠加后光强的分布. (Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)

ALVINN road follower data set

多目标优化问题的解法--牛顿法，用matlab编写(Multi-objective optimization-Newton method )

AS1500CD user manual

MPC CONTROLLER LOGARITHMS

neumerical methods-matlab

Uncertainty Quantification, Multilevel Monte Carlo, Probabilistic Collocation Methods

这是一个小波去噪MATLAB源程序,用于处理各种信号中的突变点以及异常点的小波去噪程序，该程序能实现各种序列中的异常点的识别。 (This is a wavelet denoising MATLAB source code for a variety of signal processing and exception point mutations wavelet denoising procedure that can achieve a variety of sequence identification of outliers.)