meansub-code

大功率分布式发电系统通常采用三相逆变器并网，由于三相逆变器系统参数耦合，传统方法设计的控制器算法复杂。在d。q坐标系下为双模式三相并网逆变器的独市和并网模式建立了数学模型．采用新的解耦方法，依据独立和并网模式控制系统超调量越小，模式切换过程中被控量的波动越小。切换过程就越平滑的原则。完成了两种模式的控制器设计，即分别应用积分环节、比例环节即可将独立模式和并网模式整定成典型的二阶系统，控制器设计简单．能取得优良的动、静态特性。仿真与实验验证了设计方法的正确性和可行性。(It is necessary to research on three—phase grid-connected inverter which a8 an important part of distributed generation．The parameters of three—phase inverter are coupling．The traditional design algorithm of the controller is complicated．The mathematicM models of stand—alone mode and grid—connected mode are established in d，q fhme． Based on the principle that the lower overshoot of the controller system，the smaller fluctuation of the controlled vailables， the smoother in transfer，controllers of two modes are designed separately，as integral and proportional regulators are separately added to stand-alone mode and g而d—connected mode．The controller has good dynamic and static char— acteristics．Simulation and experimental results varify the correctness and feasibility of the proposed method．)

分析并实现了奇异谱斜率的方法，编程实现了时域信号的检测。(And to achieve a singular spectrum analysis method of slope, programming of the time-domain signal detection.)

该程序可以仿真MSK传输系统，对初学者有帮助。(siulater the MSK transmisstion system)

自己写的,有关于在电脑上仿真手机图片的显示效果,希望有所帮助(wrote it myself, on the phone computer simulation results show the pictures, hoping some help)

说明：  微电网下逆变器pi环控制，可以仿真出结果，波形完整(Micro grid inverter PI ring under control, you can copy the micro grid inverter under PI loop control, can the simulation results, the waveform complete real results, waveform is complete)

可以计算物理学中的voigt线型，通过两个展宽的卷积实现更接近实际情况(this code could get the voigt of broad )

支持向量机SVM和核函数的MATLAB程序集(MATLAB SVM RBF SIGMOD)

双极性pwm控制技术逆变器，采用pwm技术对逆变器进行控制实现逆变功能(pwm nibianqi)

Does a picture of the dispersion relation. The figure should be compared with Figure 7.2-10 of the book. Reference: Fundamentals of Photonics-Second Edition

这是xilinx的FPGA实现各种算数运算的全部基于MATLAB的模型文件，包括加减乘除等(This is the xilinx arithmetic FPGA to achieve the full range of MATLAB-based model of documents, including multiplication and division, such as addition and subtraction)