NGPC_simplex

multi body system dynamics (multi body system dynamics by wittenberg)

Two demos illustrate use of SimPowerSystems for modeling a PV array connected to a utility grid. PVarray_Grid_IncCondReg_det.mdl is a detailed model of a 100-kW array connected to a 25-kV grid via a DC-DC boost converter and a three-phase three-level Voltage Source Converter (VSC). Maximum Power Point Tracking (MPPT) is implemented in the boost converter by means of a Simulink model using the “Incremental Conductance + Integral Regulator” technique. PVarray_Grid_PandO_avg.mdl is an average model of a 200-kW array connected to a 25-kV grid via two DC-DC boost converters and a single three-phase VSC. The MPPT controller based on the “Perturb and Observe” technique is implemented by means of a MATLAB Function block that generates embeddable C code.

多传感器数据融合：将MATLAB语言应用到多传感器数据融合中，书中给出了大量的仿真实例(multisensor Data Fusion with matlab)

the code uses cma for channel identification and equalization

说明：  天线的3D方向图形成,又助于对天线整体的认识(3Dpatten )

本目录主要包括：文档和两个源代码。 其中一个源代码是识别程序的，另一个是一个矩阵类库的，书里面也使用过，所以一并附上。 因为已经保存了训练好的网络权值，所以第一次使用识别程序时，可以直接运行\Release目录下的可执行文件，然后对图片目录中的测试图片进行读入、识别。 当然读者也可以自行用训练样本训练网络，不过要特别注意训练样本的选择，否则可能造成识别率很低。训练样本选择的原则是，尽可能的有代表性，在训练时间不至于太长的情况下，训练样本数目尽量多。 (This directory includes: documentation and two source code. One of the source code is to identify the procedure, the other is a matrix class library, the book which is also used, so be attached. Have been saved because of the trained network weights, so the first use of identification procedures, he can run Release directory Under the executable file, then the test image directory read pictures, identification. Of course, readers are free to use the training samples to train the network, but pay special attention to training samples, otherwise it may result in knowledge Do not rate very low. Training sample selection principle is that as far as possible, representative, in the long training time Buzhi Yu s case, the training Training sample size as much as possible.)

The 2D RLS algorithms is used to enhanced image contrast by adaptive filtering techniques by less error and better speed recursively.

压缩感知的贪婪迭代算法，算法使用最小二乘估计来重构信号(Greedy iterative algorithm compressed sensing algorithms to reconstruct the signal using a least squares estimation)

钻井船悬臂梁loadchart计算 ,计算悬臂梁升出船体所能承受的井心与立根盒的最大载荷。(Calculate the cantilever rigs loadchart)

使用matlab计算汽车动力性，为分析整车性能打下基础，同时作为分析整车性能的工具(Calculation of vehicle dynamics)