Matpower

example of a msk modulation in simulink.

Implementation of a rule using a Groovy script.

基于matlab的8-3编码器，使用模块实现编码，并进行封装(8-3 matlab-based encoder module using coding and packaging)

matlab的pid控制程序，单神经元自适应PID控制(matlab of pid control procedures, single neuron adaptive PID control)

采用matlab/simulink仿真环境建立捷联惯导系统的垂向通道仿真模型，利用高度气压计进行增稳仿真，取得良好的高度通道稳定的效果。(The model of vertial channel was developed in matlab/simulink.By using the high sensor to upgrade the high stability.)

说明：  matlab下枝干图的绘制 .(matlab mapping under the branches.)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

quantization wavelet to generate step signal

OFDM信道估计代码，通过LMMSE估计、LS估计、SVD估计进行研究。并通过MATLAB仿真平台进行仿真，对三种信道估计算法及它们的性能进行了仿真分析和比较。(OFDM channel estimation)

matlab下，用dspbuilder实现dds模块产生正弦波的源码(matlab under dds with the realization of dspbuilder generated sine wave source modules)