rs

某电力厂家故障录波器源代码,很全,可编译通过(A power fault recorder source code, really)

Persian calender mfile 1392 in matlab

SourceCode project in data management system

Introduction to programming finite element with matlab

仿真程序：首先需要用一个随机发生器产生（0.1）内的均匀随机数，然后再将该序列映射到对应的幅度电平｛Am｝。然后将这个范围再分成4个相等的区间，这些子区间分别对应于4个信号比特的符号00，01，10，11。检测器观察到r=Am+n，并且计算r和4种可能传输的信号幅度之间的距离，它的输出Bm就是相应于最小距离的信号电平。Bm与真正的的传输信号幅度比较，差错计数器用来对检测器产生的差错计数。(Simulation program: first need to use a random generator (0.1) the uniform random number, then the sequence is mapped to the corresponding amplitude level {Am}. Then this range has been divided into four equal intervals, these sub-intervals corresponding to four signal bits of the symbol 00,01,10,11. Detector observed r = Am+ n, and calculate r and 4 possible transmission distance between the signal amplitude, its output corresponding to the minimum distance Bm is the signal level. Bm and the real rate of transmission of the signal comparison, error detection counter is used to generate the error count.)

利用c++编程，该程序实现了不使用标准块输入访问simulink信号(Using c++ programming, the program achieved without the use of standard access simulink block input signal )

该程序是基于时间延迟求和的波束成形算法的实现，根据是结果来看有很好的效果(The program is based on the sum of the time delay beamforming algorithm, based on results, there is a good effect)

微分方程网格生成 计算传热学 离散方法 自适应网格(The differential equation of grid generation)

缺失部分方位信息的辐射计阵列有源校正 (Radiometer array azimuth information of the missing part of the active correction)

说明：  什么是Ecodynamica? Ecodynamica是普通的工具和二维元胞自动机1(CAs)。(What is Ecodynamica? Ecodynamica ordinary tools and two-dimensional cellular automata 1 (CAs).)