ICAim

电系统过电压仿真程序，基于matlab和vc的混合编程，matlab动态仿真(Over-voltage power system simulation program, based on matlab and vc mixed programming, matlab dynamic simulation)

用matlab编写的最炫民族风的音乐，效果还是不错的，可以试听一下(Coolest Ethnic music using matlab, the effect is good, you can listen to)

LMS算法，可以实现在计算机上的仿真，通过仿真可以清楚的了解结果(LMS)

有三个是谱估计的方法和一个误差分析曲面作图最后是分析对比TLS和LS的性能(Three is the spectral analysis method and an error analysis and comparison of surface mapping and finally the performance of TLS and LS)

将Iris数据集分为2组，每组各75个样本，每组中每种花各有25个样本。其中一组作为以上程序的训练样本，另外一组作为检验样本。为了方便训练，将3类花分别编号为1，2，3 。 　　使用这些数据训练一个4输入（分别对应4个特征），3输出（分别对应该样本属于某一品种的可能性大小）的前向网络。(The Iris data set is divided into two groups each of 75 samples in each group have 25 samples in each flower. One set of sample programs as more training, another group as the test samples. To facilitate training, the three types of flowers were numbered 1,2,3. Training before using these data a 4-input (respectively 4 features), 3 outputs (respectively the possibility should belong to a variety of sample size) to the network.)

AGC using Simulink and Economic Dispatch using PowerWorld

说明：  此程序是基于广义最小二乘法，运用递推算法。(This procedure is based on generalized least square method, the use of recursive algorithms.)

利用有限时域差分法对一维均匀平行板传输线特性仿真(Using the finite difference time domain method for one-dimensional homogeneous parallel-plate transmission line characteristic simulation)

matlab code for DICOM Example Files

用基本的粒子滤波算法，即SIR运行UNGM模型。通过UNGM模型显示SIR对于非线性系统的性能。(With the basic particle filter algorithm, that is, to run UNGM model of SIR. By UNGM model shows SIR for the non-linear system performance.)