UCGUI3.90notes

51单片温度报警程序，当外界温度高于设定值时，蜂鸣器报警(To avoid the temperature will be too high)

loadram 单片机编程类的东西，flash加载。下载代码分析分析(Microcontroller Programmer loadram things, flash loaded. Download the code analysis analysis)

使用超声波模块测距，测距范围 10cm--1..2m(Using ultrasonic module to measure distance, ranging range is 10cm-1.2m.)

本程序用于求解以网损、电压偏差、投资运行费用最小为目标的配电网分布式能源选址定容问题，并辅以相关文献。(This procedure is used to solve the loss, voltage deviation, minimum operating cost investment objective distribution network of distributed energy locating and sizing issues, supplemented by relevant literature.)

C51 12位 双极性 ADC MAX1272 驱动程序 STC单片机 滤波算法(A C51 12 bit bipolar ADC MAX1272 driver STC microcontroller filtering algorithm)

AT24C16在AT89S52单片机上的读写程序(In the AT24C16 microcontroller AT89S52 read and write programs on the)

说明：  基于matlab/simulink永磁同步电机的模糊PID控制仿真模型，适用于永磁同步电机，仿真效果还可以(The fuzzy PID control simulation model based on MATLAB / Simulink is suitable for PMSM, and the simulation effect can also be)

编写程序，通过8255 单元控制点阵的扫描显示，使8×8LED 点阵到小循环显示号 “□”(Programming, through the 8255 unit control the scanning dot matrix display, the 8 × 8LED dot matrix display number to small cycles " □" )

Xilinx虚拟连接，这是一种基于TCP/IP协议的通信技术，以实现JTAG功能，通过这样的连接，可以访问开发的FPGA或者SOC，而不需要通过传统的JTAG电缆。(Xilinx Virtual Cable (XVC) is a TCP/IP-based communication protocol that acts like a JTAG cable and provides a means to access and debug your FPGA or SoC design without using a physical cable. In this document are the general details of this XVC 1.0 protocol.)

此为双声道超声流量计单片机程序，经过修改可测管网热量(this is two channels ultrasonic flowmeter program on stm32l152c8t6 microcontroller)