doppler-shift

为评估TD_SCDMA下行链路联合检测接收机的性能，使用MATLAB软件进行链路仿真，本程序主要是实现用户QPSK基带调制、扩频、加扰、形成时隙、形成子帧、以及进行脉冲形成滤波，通过加性高斯白噪声信道和瑞利衰落多径信道，信道估计、联合检测等几个主要过程，整个仿真都是在基带进行的。(Link simulation to assess the performance of the TD_SCDMA Downlink joint detection receiver using MATLAB software, this program is the main user QPSK baseband modulation, spreading, scrambling to form a slot to form a sub-frame, as well as for pulse formation filter, through an additive white Gaussian noise channels and Rayleigh fading multipath channel, channel estimation, the joint detection of several major process, the entire simulation in the baseband)

GB28181安防监控标准SPVMN软件的安装和配置说明文件。(The Document of GB28181 Project SPVMN set)

说明：  OFDM信号功率谱和频谱的MATLAB实现(Realization of Power Spectrum and Spectrum of OFDM Signal by MATLAB)

利用wifi信号进行精准的定位，mit代码(locolizing using wifi)

turbo码的译码，以及包含LOGMAP和SOVA两种算法(turbo code decoding, and includes two algorithms LOGMAP and SOVA)

朋友写的C++645通讯程序，支持645-1997与645-2007,支持自已组帧程序自动添加校验码通讯，可以增加数据标识定义，里面还有部分关于费控通讯代码，挺好，拿来分享(Friend write C++645 communications program to support the 645-1997 and 645-2007, to support their own group the frame program automatically adds the checksum communications, can increase data identifies the definition, there is also a section on the fee control communications code, good for them and share)

针对通信侦查课题，通过已知先验知识和截获信号，进行找出同步序列，匹配滤波，校正频偏和相偏，均衡，解交织，译码，恢复出原序列，最终得到的序列与原序列作对比得到误码率为0(Investigation subject for the communication, by known a priori knowledge and intercepted signal conducted to identify the synchronization sequence, the matched filter, correcting frequency offset, and phase deviations, balanced, deinterleaving, decoding, to recover the original sequence, the resulting sequence with the original sequence compared error rate is 0)

这是蓝牙4.0的规范说明文档，对于了解4.0协议有所帮助。(This is the Bluetooth 4.0 specification document helpful for understanding the 4.0 protocol.)

MODBUS RTU using Attiny44 from Atmel

SLM与削峰联合算法,matlab脚本文件(Joint algorithm of SLM and clipping)