登录
首页 » matlab » communication

communication

于 2012-08-21 发布 文件大小:11979KB
0 278
下载积分: 1 下载次数: 48

代码说明:

  针对通信侦查课题,通过已知先验知识和截获信号,进行找出同步序列,匹配滤波,校正频偏和相偏,均衡,解交织,译码,恢复出原序列,最终得到的序列与原序列作对比得到误码率为0(Investigation subject for the communication, by known a priori knowledge and intercepted signal conducted to identify the synchronization sequence, the matched filter, correcting frequency offset, and phase deviations, balanced, deinterleaving, decoding, to recover the original sequence, the resulting sequence with the original sequence compared error rate is 0)

文件列表:

data_1_1_I.bin,6417072,2011-04-27
data_1_1_Q.bin,6417072,2011-04-27
ex_commu.m,3114,2012-06-13
test_raw_bit1.dat,720001,2012-06-05
train_seq.dat,642,2011-03-05
要求及先验知识.ppt,129536,2012-08-21
说明.txt,0,2012-08-21

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 12493618_EIbPLiNcTreXgYmkQDgYYXpEi
    说明:  利用叠加法pm谱,生成三维海浪波形的源程序,输入风级数,频率数和角度数得到该风级下的海浪波形;(Using the superposition method PM spectrum, the source program of three-dimensional wave waveform is generated, and the wave waveform under the wind level is obtained by inputting the number of wind level, frequency and angle;)
    2021-02-09 17:54:32下载
    积分:1
  • 信道指标
    说明:  matlab实现的信道指标计算求误码率低的信道(Calculation of channel index realized by MATLAB to find the channel with low bit error rate)
    2020-01-06 10:39:11下载
    积分:1
  • EasySerialPort
    可用于无协议串口调试和标准Modbus调试。例案:单片机无协议通信、变频器通信调试、PLC及工业仪表通信调试。(No agreement can be used for standard Modbus serial debugging and debugging. Example case: no agreement on single-chip communications, Converters debug communications, PLC and industrial instrumentation communication debugging.)
    2008-05-23 22:41:11下载
    积分:1
  • cordic
    实现可连续输入数据做三角函数变换处理,通过verilog代码实现,(It realizes triangular function transformation for continuous input data.)
    2020-06-21 22:40:01下载
    积分:1
  • BER_OFDM_OQAM
    基于MATLAB的OFDM/OQAM调制系统的仿真与误码率测试(Simulation and BER MATLAB the OFDM/OQAM modulation system test)
    2020-07-02 18:00:02下载
    积分:1
  • yapnb
    采用加权网络中节点强度和权重都是幂率分布的模型,双向PCS控制仿真,包含光伏电池模块、MPPT模块、BOOST模块、逆变模块。( Using weighted model nodes in the network strength and weight are power law distribution, Two-way PCS control simulation, PV modules contain, MPPT module, BOOST module, inverter module.)
    2017-05-15 12:45:04下载
    积分:1
  • modbus-master
    说明:  通过串口解析MODBUS协议 读开关量型的输入信号 读保持寄存器上的内容 批量写数据到保持寄存器(Resolving MODBUS Protocol through Serial Port Input signal of reading switch type Read and hold registers Write data in batches to hold registers)
    2020-06-23 20:40:01下载
    积分:1
  • jian
    说明:  整个仿真系统是从发射端、瑞利信道、接收端大致的过程(The entire simulation system is a rough process from the transmitter, the Rayleigh channel, and the receiver)
    2020-08-25 16:21:59下载
    积分:1
  • SpectrumBasedCellularNetworks
    spectrum cellular networks
    2010-02-11 01:46:04下载
    积分:1
  • communication
    本文件包含通信所有过程,从调制,扩频,发送到接收,经过解扩,解调等。其中信道可以随机产生时变的多径信道。()
    2021-04-07 15:19:01下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载