Pendulum

说明：  bch，的编码。。在matlab上运行的。。无限接(bch)

I would like to receive alogrithmes and programs in matlab for the mastery of this langaga thank you very much

conventional simulink statcom

新的2维角度估计的高分辨方法。该方法首先建立基于范数约束的最优化问题的目标函数；然后用迭代算法沿均匀面阵接收数据的方位向求最小化目标函数的稀疏解，得到方位、俯仰角耦合的空间角频率，并分离信号；最后对每个分离的信号，沿面阵俯仰向求稀疏解，得到信号的俯仰角，进而求得对应的方位角。(The new high-resolution 2-D angle estimation method. Firstly, the establishment of an objective function optimization problems based on norm constraint then iterative algorithm along with uniform orientation plane array receives data to seek to minimize the objective function is sparse solution, get directions, spatial frequency coupling angle pitch angle, and separated signals Finally for each signal separation along the sparse area array pitch to seek solutions to obtain the pitch angle of the signal, and then obtain the corresponding azimuth.)

采用Simulink仿真工具，通过对二元对称信道的仿真，研究信道编码（如Turbo码等）对误码率的改善情况。(Simulink simulation tool used, through the binary symmetric channel simulation to study the channel coding (such as Turbo code, etc.) on the error rate to improve the situation.)

说明：  给定10帧点云，利用ICP的方法估计出机器人在这10帧的轨迹，并实现局部点云地图的生成(Given 10 frames of point clouds, the trajectory of the robot in these 10 frames is estimated by ICP method, and the local point cloud map is generated)

线性卷积的FFT实现 重叠相加 重叠保留(Implementation of linear convolution of the FFT overlap-add Overlapping)

网络平均时延的计算，通过两种算法互相验证结果(Average network delay calculation results in two mutual authentication algorithm)

用matlab语言写的ID3(Quinlan s ID3 classification tree algorithm)算法,用于模式分类(Matlab language used to write the ID3 (Quinlan s ID3 classification tree algorithm) algorithm for pattern classification)

说明：  自适应控制的例程 文件samp.m使用matlab6.5通过(adaptive control routines samp.m documents through the use of matlab6.5)