MATLAB-Tips-and-Tricks

PSCAD，DC-AC-DC直流变压器，中间为100Hz高频变压器，一边实现Vf控制，另一边实现UdcQ控制。先在PSCAD中加载dqo_new_lib.psl后再加载DC_AC_DC_100Hz.psc。(PSCAD, DC-AC-DC DC transformer, the middle of 100Hz high-frequency transformer, while the realization of Vf control, the other side to achieve UdcQ control. First load dqo_new_lib.psl in PSCAD and then load DC_AC_DC_100Hz.psc.)

根据所限定的条件，绘制出并联机构运动空间图(accoring the limit you need to choose the available degree combinations)

两通道fxlms降噪matlab仿真亲测能用(Fxlms two-channel noise reduction can be pro-test simulation matlab)

matlab算法，用bp网络进行训练，然后进行分类的一种算法，很成功(matlab algorithm, using bp network training, followed by a classification algorithm, very successful)

本段代码主要是为了实现讲多光谱图像进行光谱分离然后再合并成一种可以在matlab中显示的格式.tif的图像，同时保证了原始的图像信息不丢失(This code is mainly to achieve multispectral images speak for spectral separation and then combined into a format that can be displayed in matlab. Tif image, while maintaining the original image information is not lost)

三相并网逆变器，电压环和电流环双环控制，电流环参考值有功率控制，实现PQ控制( 制 Three-phase grid-connected inverter, voltage loop and current loop dual-loop control, current loop power control reference values are realized PQ control)

基于matlab的心电信号QRS波检测与分析，课程设计方案(ECG QRS detection and analysis matlab-based curriculum design)

说明：  基于EEMD的回转支承故障多尺度ICA方法 检测与诊断(EEMD-based multiscale ICA method for slewing bearing fault detection and diagnosis)

4RRR运动学相关程序，添加了多种解决方案，也是一个不断变化的图形用户界面，对几乎所有的模拟参数允许使用。 (4RRR kinematics procedures, adding a variety of solutions, but also a changing of the graphical user interface, almost all of the simulation parameters allowed.)

说明：  设基带码元传输间隔为0.1秒，FSK调制参数分别设置频率间隔为5Hz和20Hz，相位分别设置为不连续的和连续的两种。试对比观察4元FSK调制输出等效低通信号的功率频谱。(Let the baseband symbol transmission interval is 0.1 seconds, FSK modulation parameters are set the frequency interval of 5Hz and 20Hz, respectively, set to the discontinuous phase and continuous two. Observation of test 4 yuan FSK modulation output equivalent low pass signal of the power spectrum.)