BPSK_M

MATLAB主成分分析法,对于数学建模的同学很有帮助(PCA MATLAB)

matlab入门级程序，对matlab基础仔细说明，比较简单(matlab entry-level program, the foundation is simple to use)

雅克比迭代求解线性方程组课设,实现用SDRAM运行nios，同时用SRAM保存摄像头数据，最小均方误差等算法的MSE的计算。( Jacobi iteration for solving linear equations class-based, Implemented with SDRAM run nios, while saving camera data SRAM, Minimum mean square error MSE calculation algorithm.)

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)

MATLAB遗传算法工具箱及应用 这是一本不错的书(MATLAB genetic algorithm toolbox and its application..it is a good book!)

计算滑动轴承滑动效率和受的摩擦力，并绘制出曲线(Calculation of efficiency and by the sliding bearing sliding friction, and draw out the curves)

LMD算法实现，学习局域均值分解的可以参考下(LMD algorithm, learning the local mean decomposition can refer)

衰落信道的仿真．可以运行，里面有很多，很不错(fading channel)

List of m-les, with initial comments lines, from F:matlabComp*.m. This list was printed 22-Oct-2010

ASK,FSK,PSK信号调制及用FFT法进行频率估计(ASK signal modulation and the FFT algorithm with frequency estimation)