multiaccess_handover_load

说明：  关于sd卡在嵌入式应用中的资料，是网友亲自翻译的，适用于初用sd卡的爱好者(On the sd card applications in the embedded information is personally Netizen translation for the beginning of the lovers with sd card)

说明：  汽车行业CAN通讯SAEJ1939标准英文版(Auto Industry CAN Communication SAEJ1939 Standard English Edition)

Diameter协议结构原理,Diameter协议在IMS的基本应用 (Diameter descriptor)

Multi-Carrier Cooperative Wireless Communication

电力最常用的规约的学习资料，包括101,102,103,104，modbus，cdt，其中104还有测试程序，及解析工具；( The most commonly used power statute learning materials, including 101,102,103,104, modbus, cdt, where there are 104 test procedures, and analysis tool )

针对数字卫星常用的 7 种通信信号调制方式(QPSK、8PSK、16QAM、32QAM、64QAM、16APSK、32APSK)，对零中心归一化瞬时幅度谱密度最大值、四次方谱、幅度、高阶累积量四种特征参数进行了分析，提出了一种联合特征参数的信号调制识别方法．(Aiming at seven communication signal modulation modes commonly used in digital satellite (QPSK, 8PSK, 16QAM, 32QAM, 64QAM, 16APSK and 32APSK), four characteristic parameters of zero-center normalized instantaneous amplitude spectral density, quadratic spectrum, amplitude and high-order cumulant are analyzed, and a signal modulation recognition method of joint characteristic parameters is proposed. Method.)

描述了智能天线在无线通信环境下的各种应用。(Describes a smart antenna in a wireless communication environment, a variety of applications.)

说明：  求解双层规划问题常用的算法有极点算法、直接搜索法、下降法和非数值优化方法(如模拟退火算法、遗传算法等)，遗传算法的求解思路是：首先对上层的决策变量编码，代人下层规划模型，通过求解下层模型的决策变量值，代入上层模型计算适应度值，然后进行交叉、变异、选择操作，最后求出最优解。(Solving Bilevel Programming Problems with pole algorithm commonly used algorithms, direct search method, descent and non-numerical optimization methods (such as simulated annealing, genetic algorithms, etc.), genetic algorithm for solving approaches: the first on the top of the decision variable coding, on behalf of the were lower programming model, by solving the lower model of decision variables values into the upper model on behalf of the fitness value, and then crossover and mutation, select Options, and finally get the best solution.)

说明：  thesis document used for ph.d degree

中国移动通信互联短信网关接口协议CMPP3(CMPP3)