登录
首页 » matlab » PowerFlowLzk

PowerFlowLzk

于 2012-05-13 发布 文件大小:1KB
0 247
下载积分: 1 下载次数: 5

代码说明:

  电力系统配电网络计算潮流的程序,可以使用的。(Power flow calculation in electric power system)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • RBFlw7
    这是matlabdaima,用来计算RBF输出值很有效(This is matlabdaima, used to calculate the RBF output is valid)
    2010-09-13 15:51:33下载
    积分:1
  • code-capture-of-dsss-system
    本文主要利用matlab编程工具对直接序列扩频通信的捕获过程进行仿真。仿真主要基于滑动相关法的有关理论,先讨论扩频仿真中起着重要作用的m序列的生成问题,尔后讨论调制信号的产生,然后在信号的捕获中分步讨论,先对捕获的流程进行简单的仿真,再依次加入噪声和多普勒频移后进行捕获仿真(In this paper, using matlab programming tools for direct sequence spread spectrum communication capture process simulation. Simulation of the sliding correlation method is based on the theory, first discuss the simulation plays an important role in spreading the m sequence generation problem, the modulation signal generation and later discussed, and the signal captured by stepping discussion processes the captured first simple simulation, and then followed by adding noise and Doppler frequency shift after the capture simulation)
    2013-09-04 11:53:17下载
    积分:1
  • 1
    说明:  感应双馈发电机系统的仿真,已经完美封装好,参数可自行更改(The simulation of the induction doubly fed generator system has been perfectly encapsulated, and the parameters can be changed by themselves)
    2020-04-13 18:49:12下载
    积分:1
  • xiebo
    非线性负荷对线路谐波的影响,可分析各个频率成分的含量(Influence of nonlinear harmonic load on the line, it can analyze the content of each frequency component)
    2015-07-06 08:41:52下载
    积分:1
  • Pointers-and-Arrays
    This Chapter deals with POinters and Arrays. Sample Programs are given to workout in C++ environment.
    2014-09-16 23:41:56下载
    积分:1
  • main
    detecting woods by images
    2013-12-03 14:47:18下载
    积分:1
  • RBF
    Radical basic function to predict
    2012-04-05 15:33:10下载
    积分:1
  • Link-a-System-Level-OFDM-Simulator
    针对OFDM系统,分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度,采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)
    2011-08-09 11:00:53下载
    积分:1
  • Matlabsysu2014OK
    有关matlab的数值计算部分,和矩阵数据结构相衔接,方便初学者系统理论的学习(Numerical section on the matlab, and matrix data structure convergence, easy to learn for beginners systems theory)
    2014-11-09 16:38:09下载
    积分:1
  • MATLAB65
    Matlab的bpsk,可控信噪比仿真系统(Matlab' s bpsk, controllable SNR simulation system)
    2013-12-04 12:56:38下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载