matlab

应用UCD3138控制的数字LLC DC/DC变换器(LLC Converter controlled by UCD3138)

基于无刷直流电机的的矢量控制程序，可以在simulink中直接建模，系统为开环系统。(Brushless DC motor based on vector control program, you can direct modeling in simulink, the system is open-loop system.)

在rayleigh信道下能量检测是数值计算(energy detection)

基于matlab的视频监测与跟踪，用于实现视频监控中的目标监测与跟踪。(Matlab-based video monitoring and tracking, used to achieve the goal of monitoring and tracking in video surveillance.)

ti so PAPR trong LTE-Advance

分段异常信号实验，几个不同频率的信号叠加用HHT方法进行分解，是我做实验用的信号，验证无误，(Abnormal signal sub-experiment, several different frequency signal superimposed with the HHT method of decomposition, I did experiment with the signal, verify the correct)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

双极性矩形随机信号的归一化功率谱密度 HDB3码的编译码（要求给出眼图）(Normalized power spectral density HDB3 code codec bipolar rectangular random signals (required to give the eye))

VNS algorithm matlab powerful source code

matlab命令大全。姚东，王爱民，冯峰，王朝阳等编著(matlab command Daquan. Yao Dong, Wang Aimin, Feng Feng, Chao-Yang Wang, eds)