登录
首页 » matlab » zishiyinglvbo

zishiyinglvbo

于 2011-06-01 发布 文件大小:19KB
0 290
下载积分: 1 下载次数: 9

代码说明:

  一种自适应滤波算法,适应滤波、去噪的一个小程序(An adaptive filtering algorithm )

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • lqr
    一级倒立摆系统采用lqr方法控制,使其达到平衡状态(Inverted pendulum system using lqr to control, to reach the equilibrium state)
    2010-09-30 21:15:22下载
    积分:1
  • 3
    说明:  为了采集准确的心电信号,设计了一套基于瞬时心率信号抗干扰测量的方法,针对微弱并易受干扰的心电采样信号,进行有效地硬件以及软件滤波,通过软件数字滤波算法,得到真实的心率信号(Set based on the instantaneous heart rate signal immunity measuring method to collect accurate ECG, ECG sampling signal for the weak and vulnerable to interference, hardware and software filtering, digital filtering algorithm through software, get real The heart rate signal)
    2013-04-01 16:39:47下载
    积分:1
  • case57
    IEEE57节点电力系统标准参数和潮流数据(IEEE57 node power system standard parameters and trend data)
    2012-06-04 15:19:57下载
    积分:1
  • Texto-integral
    Paper Abstract – An adaptive control of Distributed Generation (DG) to provide predictable active power output at the primary distribution substation is described. Often, distribution networks accommodate renewable energy different energy sources and thus using different energy conversion sources. As the amount of generation that comes intermittent renewable sources (e.g. wind energy) increases, network operators start to concern with the uncertainty of generation. However, when the power output intermittent renewable sources is predicted, the network operators can reduce the operational costs of the network and the DG owners may go on the market. Thus, our challenge with this work was to develop an algorithm which can predict the active power output the aggregation of wind and biomass energy at the primary distribution substation of a typical distribution network. Wind and biomass energy plant are onto the same distribution network but not necessarily onto the same feeder.
    2014-12-04 00:36:38下载
    积分:1
  • 互相关求时延差
    说明:  利用互相关求解时延差,入门程序,仅供参考(Using cross-correlation to solve delay difference, introductory procedure, for reference only)
    2020-08-17 16:58:23下载
    积分:1
  • multipath
    在matlab下实现多径信道仿真,计算误比特率(Matlab achieved in multi-path channel emulation, bit error rate calculation)
    2007-08-22 11:07:23下载
    积分:1
  • maxcost
    “基于Floyd最短路算法的Ford和Fulkerson迭加算法”的最小费用最大流算法,其基本思路为:把各条弧上单位流量的费用看成某种长度,用Floyd求最短路的方法确定一条自V1至Vn的最短路;再将这条最短路作为可扩充路,用求解最大流问题的方法将其上的流量增至最大可能值;而这条最短路上的流量增加后,其上各条弧的单位流量的费用要重新确定,如此多次迭代,最终得到最小费用最大流。 (" Floyd shortest path algorithm based on the Ford and Fulkerson algorithm superposition" of the minimum cost maximum flow algorithm, the basic idea is: the flow of each arc on the unit cost as a length, with Floyd for the most short-circuit method to determine a from V1 to Vn of the most short-circuit then this can be expanded as the shortest way, by solving the maximum flow of traffic on the way to its maximum possible value and this increased the flow of the shortest path, on which the arcs of the unit to re-determine the cost of traffic, so several iterations, finally get the minimum cost maximum flow.)
    2010-12-22 17:27:32下载
    积分:1
  • attachment(1)
    zig-zag顺序扫描,从而达到实现图片压缩量化编码(zig-zag scan order to achieve the realization of image compression quantization coding)
    2011-05-04 20:15:25下载
    积分:1
  • MATLAB-Highpass-filter
    基于matlab的 高通滤波器类别, 设计方法,应用等。(matlab highpass filter)
    2011-12-20 11:19:33下载
    积分:1
  • 1
    倒频谱的matlab实现代码。包含倒频谱的代码及调用文件。(Cepstrum matlab code. Contains the the cepstrum code and call the file.)
    2013-05-14 11:15:20下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载