KNNalgorithm

用于epcm的uart开发的代码，含有matlab和c代码的对比与应用(Uart for the development of the epcm code, matlab and c contain comparing and application code)

非线性系统的PID鲁棒控制，基于NCD优化的非线性PID控制(Nonlinear systems Robust PID control of NCD-based PID control of nonlinear optimization)

说明：  Volterra自适应预测的 matlab 程序,用于自适应预测测试和混沌序列的相空间重构（转）(Volterra adaptive prediction Matlab procedures for testing and adaptive prediction chaotic sequence of phase space Reconstruction (switch))

这是CISS会议上发表的著名论文“Tensor Canonical decomposition based method for blind identification of MIMO system with 3-input 2-output case”的源程序，主要是讲基于张量规范分解的多天线系统的忙识别问题，里边包含了相应的文章，可以一起对照着看。(conference on the famous treatise "Tensor Canonical deco mposition based method for blind identificati on of MIMO system with 3-input 2-output case, "the source procedures, primarily based on stress tensor decomposition of standardized multiple antenna system to identify problems in the 1980s, contained inside a corresponding article, can work together to look to see.)

simulation antenna parapol

使用MATLAB仿真ask信号，并画出眼图，使用窗函数对数据进行功率谱计算，并画图(Use the data window function power spectrum calculation, and drawing)

file is uploaded as per instructions

结合Matlab的GUI和神经网络开发出来的界面(Combination of Matlab' s GUI and neural network developed interface)

说明：  利用winpcap编写的，直接从链路层收取数据帧的小程序，希望能有点用处。(use winpcap prepared directly from the data link layer frame collection of small procedures in the hope that this will usefulness.)

此源码用于对一些非线性的方程组进行求解，时间复杂度比较小，效率比较高(This source is used for some non-linear equations is solved, the time complexity is relatively small, more efficient )