Systemview-software-simulation

单载波系统在高斯白噪声和多径信道条件下的仿真——加入独立字导频且采用最小二乘信道估计(Single carrier system in gaussian white noise and multipath channel under the condition of the simulation to join the independent word frequency and the least square estimation channel )

语音信号的采集与处理，数字信号处理课设，能量谱分析计算,小波包分析提取振动信号中的特征频率。( Acquisition and Processing of the speech signal, digital signal processing class-based, Energy spectrum analysis and calculation, Wavelet packet analysis to extract vibration signal characteristic frequency.)

基于MATLAB搭建的超奈奎斯特（FTN）仿真系统(Based on Super Nyquist (FTN) MATLAB simulation system built)

encoding binary data using non return to zero

51单片机MODBUS主机通信程序，平台KEIL4。使用MODBUS SLAVE测试成功。(51 MCU MODBUS host communication program, platform KEIL4. The MODBUS SLAVE test was successful.)

说明：  运行在QT 上，而且基于TCP协议上的，连接服务器的服务端口(TCP-based server service ports on QT)

说明：  基于子空间投影的 CSMG 波束形成算法，是一种将子空间投影与波束形成技术相 结合的抗干扰方法。该方法首先构造干扰子空间的正交补空间，再将天线阵列接收到的空时信号矢量向其投影，然后对投影后的输出信号采用具有严格约束最小功率的抽样矩阵梯度（CSMG）算法，在固定方向上进行波束形成，最后捕获、定位及解算出每个波束得到的无干扰数据等，可以有效地抑制干扰信号，同时又可以更好的保留期望信号。(The algorithm of the CSMG beamforming based on subspace projection, which is a combination of the Subspace projection and beam forming technology. Firstly, the data vector received by antenna array is projected onto the interference subspace, which is orthogonal to interference subspace for achieving interference suppression. And then, by using the method of the strictly constrained minimum power sampling matrix gradient(CSMG), after the projection of the subspace, the signal is beamformed in a fixed direction. Finally, for jammer-free data of each beam achieved to capture, locate, solute and so on. The ability of the suppress interference by this method, which can be more effectively, and keep the desired signal better.)

说明：  降低OFDM系统PAPR的pts算法的仿真程序，已经在matlab下仿真过。(lower OFDM algorithm pts PAPR of the simulation program, already under Matlab simulation too.)

频谱感知，生成采样频率，进行能量检测，采用matlab算法(Spectrum sensing, generation of sampling frequency, energy detection, using matlab algorithm)

说明：  SCMA系统中的PM-MPA检测，信道采用瑞利信道，迭代次数为6(For PM-MPA detection in SCMA system, Rayleigh channel is adopted and the number of iterations is 6)