chaos

计算信道容量的matlab程序，给出了不同的发射天线和接受天线下的容量图(Calculation of channel capacity of the matlab procedure, given the different transmitting antennas and receiving antennas of capacity plans)

说明：  MATLAB软件基础，详细介绍了matlab软件的基础操作。(MATLAB software foundation, described in detail the basis for operation of matlab software.)

this is a powerful toolbox for model predictive control in matlab

File with compression factor of the particle swarm algorithm, the weight to improve particle swarm optimization, adaptive weighting method, the random weighting method, particle swarm optimization variable learning factor, learning factor of asynchronous change, the second-order particle swarm optimization, second-order oscillating particle swarm algorithm, chaotic particle swarm optimization, hybrid particle swarm optimization, hybrid particle swarm optimization, simulated annealing algorithm

说明：  学习matlab的资料，包含matlab的练习题和上机训练(Learn matlab materials, including Matlab exercises and computer training)

抑制载波双边带调幅　相干解调　DSBMODE 与离散大载波AM不同(Carrier suppression amplitude modulation with coherent demodulation bilateral DSBMODE with different discrete large-carrier AM)

This model can produce the characteristic of induction motor

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

什么数据库源码太复杂 搞不懂了码重复或已经存在(What database do not understand source code is too complex to repeat the code or already exists)

用MATLAB语言编写的pade近似程序，本人保留版权(the analysis of pade)