Untitled

介绍了一种可在较短时间内检测到数字电视国标系统工作模式的方法。该方法利用帧头PN序列和PN序列扩展保护部 分的相关特性、循环特性以及0FDM信号部分的周期特性进行判决，可达到很好的检测效果，该方法同时可加入跟踪模块对系统 工作模式的突然改变作出反应。还介绍了两种可以在硬件资源和性能上进行折中的检测方法(Describes a method can be detected in a relatively short period of time to a digital television GB system working mode. The method utilizes the correlation characteristics of the the header PN sequence and the PN sequence extension protective portion, the cycle characteristics of the cycle the characteristics and 0FDM signal portion judgment can achieve good detection results, the method at the same time tracking module may be added to the system working mode sudden change the response. Also describes two hardware resources and performance compromise detection method)

structural similarity index

基于频域做的图像超分辨率重建的matlab源码(Super-resolution (SR) are techniques that in some way enhance the resolution of an imaging system. There are different views as to what is considered an SR-technique: some consider only techniques that break the diffraction-limit of systems, while others also consider techniques that merely break the limit of the digital imaging sensor as SR.)

用matlab进行发送天线为2根，接收天线为1根的mimo信道空时分组码的性能仿真。(Using matlab to send antenna 2 and receiving antennas to one of mimo space-time block codes channel performance simulation.)

说明：  matlab键盘输入模型程序，用simulink制作。在7.0以上版本直接运行 运行过程中按一下键盘就会看到示波器上出现一个脉冲信号。(Matlab keyboarding model procedures used Simulink production. In version 7.0 to run over the course of operation under the keyboard will see what appeared on an oscilloscope pulse signal.)

完成阵列信号处理中MUSIC算法的仿真，并且可以通过改变参数来进行性能验证(Complete array signal processing simulation MUSIC algorithm, and can change the parameters for performance verification)

CACAL Calibration routine for computing the camera parameters using weighted least squares. The initial values are solved by using the DLT method and the final parameter values are obtained iteratively

计算单点相移光纤光栅的反射谱,计算单点相移光纤光栅的反射谱(Single point calculation phase shifted grating reflection spectrum)

针对正弦信号的PID响应进行控制，系统采用基于S函数的simlink仿真。(In view of the sine signal response to the PID control, the system adopts simlink simulation based on S function.)

本程序用于完成BPSK、QPSK、8PSK的调制仿真。并可任意扩展到MPSK和MQAM。程序分成三个部分：phase.m对基带码元序列进行脉冲成型，可选矩形脉冲，升余弦脉冲和平方根升余弦脉冲； model.m 为主程序，完成各种信号的基带星座图映射、脉冲成型和调制； command.m给出一个简单的频谱显示测试。(This procedure for the completion of BPSK, QPSK, 8PSK modulation simulation. Arbitrary and may be extended to MPSK and MQAM. Program is divided into three parts: phase.m symbol of the baseband shaping pulse sequences, optional rectangular pulse, the square root raised cosine pulse and raised cosine pulse model.m-based procedures, completed a variety of base-band signal constellation mapping , pulse shaping and modulation command.m given spectrum shows a simple test.)