GQA

这个程序的功能主要是完成对输入二进制信号序列的QPSK和8PSK调制与解调。(This program is the simulation of QPSK and 8PSK modulation and demodulation.)

编写一个MATLAB函数，实现快速卷积算法，给出一个实例。用一个N点离散傅立叶变换同时计算两个N点实序列的离散傅立叶变换。(The preparation of a MATLAB function, fast convolution algorithm, given a case in point. With a N-point discrete Fourier transform at the same time calculation of the two N-point real sequence of discrete Fourier transform.)

说明：  Ku波段低相噪频率源的研制，KU波段下行转发器发射功率大（大约在100W以上），能量集中，方便接收，，，(the research about Ku)

MATLAB指定坐标轴的范围源程序！RANGE OF SPECIFIED COORDINATE AXIS!(MATLAB designated coordinate axis of the source! RANGE OF SPECIFIED COORDINATE AXIS!)

说明：  快速傅里叶变换 (FFT) 实现，给定信号x(t)=sin(2πf0t)，f0=50Hz，对x(t)以fs=200Hz进行抽样，抽样点数为N=16。编写程序实现对x(n)的快速傅里叶变换，求得相应的X(K)。(Fast Fourier Transform (FFT) to achieve a given signal x (t) = sin (2πf0t), f0 = 50Hz, for x (t) with fs = 200Hz sampling, the sampling points is N = 16. Procedures for the preparation of x (n) of the fast Fourier transform, obtained by the corresponding X (K).)

此程序为地震勘探中常用的子波处理程序，可以适用于信号的频谱分析，地震信号的时频分析等等(This procedure is commonly used in seismic wavelet processing, can be applied to the signal spectrum analysis, time-frequency analysis of seismic signals, etc.)

Ball on Beam Controller Matlab m.file and simulink.(1)

SANKHYA is an any base to any base convertor .

基于39节点电力系统合闸角调控过程中的机组和负荷的灵敏度计算(Based on 39 bus power system to calculate the standing phase angle regulation of the crew and the load sensitivity)

matlab file for cut and copy and paste....check it out