point3linear

基于合泰单片机HT66F70A的一个实时时钟程序，利用定时器1，利用外部低速振荡器作为时钟源。(Based on a Thai microcontroller HT66F70A of a real-time clock program, using a timer 1, the use of external low speed oscillator as a clock source.)

51单片机驱动LCD1602显示大段汉字动态滚动显示(51 single-segment display driver LCD1602 large dynamic scrolling display of Chinese characters)

Circuito de diseñ o de iluminacion auxiliar con luz fluorescente

利用28335自带的ADC采集两路模拟正弦信号，用DMA方式将采样值写入内存，用epwm控制采样周期。利用FFT求得两路正弦信号的相位差。(Sampling two analog sinusoidal signals, write them to the memory by DMA controller. The sampling period is controlled by the EPWM module. Calculate the phase difference by FFT method.)

说明：  【68】W25Q16存储芯片数据读写实验(思修电子)([68] W25Q16 Memory Chip Data Reading and Writing Experiment (Reflective Electronics))

SubVi which let you easily add splash screen to any other Vi.

说明：  这是基于开发板LPC1114的源码程序，是用C语言编写，关于液晶显示屏的配置和实现同时它也是一个完整的模板，可以在此基础上添加其他程序用于开发板的学习，是一个完整的模板，可直接使用。(This is based on the development board LPC1114 source code program, is written in C language, on the LCD display configuration and implementation at the same time it is a complete template, you can add other programs on this basis for the development board learning, is a complete template, can be used directly.)

关于LQ-79xxM单路全桥使用说明及程序(About the LQ- 79 single bridge XXM instructions and procedures )

交通信号灯的功能与实现，自己做的，注意端口(stc89c52rc keil)

说明：  此代码是基于stm32对电压采集、频率测量、脉宽测量及显示的综合应用。(This code is based on the comprehensive application of STM32 to voltage acquisition, frequency measurement, pulse width measurement and display.)