tridiagLUsolve.m

三电平二极管钳位拓扑结构的仿真，对多电平变换器拓扑结构有初步了解，适合新手学习。(Simulation of three-level diode-clamped topology, multi-level converter topologies have a preliminary understanding, suitable for beginners to learn.)

OFDM系统的matlab simulink仿真框图，能设置不同参数进行仿真。(OFDM system simulation matlab simulink diagram can set different parameters for simulation.)

matlab所用到的插值算法基本都包含在内！(include all of algorithm inmatlab！)

space vector mudilation pwm in matlab winows xp

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

this is simple recursion code for beginners...

rejectaccept method for monte carlo simulation

System,烈焰行动源代码文件,SystemSystem(System, flames action source code files)

surface acoustic wave for filter correlation

说明：  simulink的基础教程，很初级和适合新手学习(simulink tutorial basis, it is suitable for beginners to learn the primary and)