UVForMatlab

Analysis of outage probability in mobile cellular system due to co channel interference.

用MATLAB实现卡尔曼滤波，达到对动目标的实时跟踪，程序调试无误，完美运行。(Kalman filter using MATLAB to achieve real-time tracking for moving target, program debugging and correct, perfect run.)

this is a very interesting paper, ple read it TransmitAntennaSelectionSchemeswith ReducedFeedbackRate, I will upload source code later. I am finding it in my computer

bitmap representation of image

目前心率变异性分析已成为当今生物医学工程研究的一个热点，再次我把我分享的心电信号的HRV分析工具上传，更好的服务正在研究这个方向的同行。(heart rate variability analysis tools)

说明：  16QAM的数字通信系统的仿真，包括调制解调，上下变频，加入了高斯白噪声，并且每个步骤都生成相应的图形(16QAM digital communication system simulation, including the modulation and demodulation, frequency conversion from top to bottom, by adding a Gaussian white noise, and each step to generate the corresponding graphics)

matlab对语音信号中断点检测算法的一种实现。(matlab on the voice signal detection algorithm of a breakpoint to achieve.)

杨氏双缝干涉 两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2, 满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ, 最后可得公式如下： ， 最后光强I=4I0cos2（Φ/2）。 观察相干光叠加后光强的分布. (Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)

matlab绘制指南针，能够调整位置，大小和让其旋转一定角度，很实用(Matlab to draw the compass, it can adjust the position, size, and let the rotation Angle, very practical)

一种新的退避算法，用matlab仿真来实现该算法(a new way to complete the BP_decode)