-
3.1
《数字信号处理》(程佩青第3版)课后实验程序第3章第1题实验(" Digital Signal Processing" (Cheng Peiqing version 3) after-school programs Chapter 3 Experiment 1 Experiment title)
- 2010-08-13 01:58:28下载
- 积分:1
-
Simulink1
说明: 介绍SIMULINK的电子文档,很实用,内容很详细,对于利用SIMULINK搭建模型仿真的同学很实用(Introduction SIMULINK electronic documents, it is practical, the content is very detailed model for simulation using SIMULINK to build the students very practical)
- 2011-03-14 09:31:52下载
- 积分:1
-
circular_array
说明: 均匀圆阵波束形成,一个干扰情况下的自适应波束形成;双干扰下的均匀线阵波束形成(Uniform circular array beamforming, interference under an adaptive beamforming)
- 2011-03-25 23:21:31下载
- 积分:1
-
boost
boost升压电路 matlab 调试成功 输出曲线很不错(boost matlab prefect)
- 2012-03-17 22:26:42下载
- 积分:1
-
city-develop
matlab 城市发展模拟,地理系统建模的小程序(matlab city develop)
- 2014-08-10 23:36:47下载
- 积分:1
-
chap4
.已知某炉温控制系统,要求温度保持在600℃恒定,针对该控制系统有以下控制经验:
(1)若炉温低于600℃,则升压,低的越多升压越高;
(2)若炉温高于600℃,则降压,高得越多降压越低;
(3)若炉温等于600℃,则保持电压不变。
设模糊控制器为一维控制器,输入语言变量为误差,输出为控制电压。输入输出变量的量化等级为7级,取5个模糊集,试设计隶属度函数误差变化划分表,控制电压变化划分表和模糊控制规则表。
(Known for a temperature control system that requires a constant temperature is maintained at 600 ℃, the following control experience for the control system:
(1) If the furnace temperature is below 600 ℃, the step-up, the more the higher the lower the boost
(2) if the furnace temperature is higher than 600 ℃, the blood pressure, high blood pressure, the lower the more
(3) If the furnace temperature is equal to 600 ℃, then keep the voltage constant.
Set of fuzzy controller for one-dimensional controller, input linguistic variables for error, the output control voltage. Input and output variables of quantization levels for seven, take five fuzzy sets, membership function test design error variance divided table, partition table and the control voltage variation fuzzy control rule table.)
- 2015-04-10 21:53:18下载
- 积分:1
-
AUV六自由度模型
简化的AUV的6自由度运动仿真程序,使用龙哥库塔法。(a simplified auv model,a matlab example)
- 2020-06-30 14:40:02下载
- 积分:1
-
MATLAB_HOG
hog特征提取,应用matlab但是没有opencv简便,仅供参考。(hog feature extraction, application matlab but no easy opencv, for reference purposes only.)
- 2014-08-25 15:25:04下载
- 积分:1
-
MATLAB-workshop-lecture-2
matlab detailed introduction updation lecture 2
- 2014-01-13 21:22:31下载
- 积分:1
-
dpll_m
DPLL implementation in matlab
- 2010-11-21 00:28:49下载
- 积分:1