BPSK

web版微信协议分析。当前分析到登陆部分。举一反三，后续的拉取好友列表和发送消息等协议都好分析出来了。作者：孙强壮。(The web version of the micro-channel protocol analysis. Current analysis to the landing part. Giving top priority to, the subsequent pull friends list and send messages agreements out a good analysis.)

说明：  主动锁模光纤激光器，利用强度调制器在腔内产生周期性的损耗调制，产生了超短脉冲。(Active mode-locked fiber)

说明：  5. 在三条径的瑞利信道中，对于直接序列扩频： (1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法，接收机分别采用等均益合并、最大比合并。用Simulink进行仿真，画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已经同步，请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已经同步，请设计DS-CDMA一种具体的频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(5. In three-path Rayleigh channel, for direct sequence spread spectrum: (1) please design a specific code division navigation aided channel estimation method for ds-cdma, and adopt equal-beneficial combination and maximum ratio combination for receivers respectively.Simulink is used to simulate and draw the relationship curve between bit SNR and channel estimation mean square error and the relationship curve between bit SNR and bit error rate. (2) assuming that the frequency has been synchronized, please design a specific single-stop sliding correlation time synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and the acquisition probability curve. (3) if the time has been synchronized, please design a specific frequency synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and frequency synchronization error curve.)

说明：  基本的调制解调程序集(包括BPSK,QPSK,QAM,GMSK等) 基本的调制解调程序集(包括BPSK,QPSK,QAM,G(Basic modulation and demodulation assembly (including BPSK,QPSK,QAM,GMSK, etc.) basic modulation and demodulation assembly (including BPSK,QPSK,QAM,G))

在CBuilder中如何控制游戏手柄，对手柄编程(How to control the game in the CBuilder handle, to handle programming)

利用MATLAB实现多用户的扩频通信的发送和接受，程序可以直接跑，不需要改动！(The use of MATLAB implementation of multi-user spread spectrum communication send and receive, the program can be directly run, no changes!)

gsm11.11 gsm11.14规范，用于gsm 的开发(gsm11.11 gsm11.14 norms for the development of gsm)

learning c++. it is good for start and beginners

用MSCOMM控件控制FXPLC全部输出/全部关闭/单独输出(MSCOMM control with full output control FXPLC/All off/single output)

说明：  802 11a OFDM MATLAB simulation code! (recommended)