ofdm

16QAM调制与解调程序，使用matlab运行(16QAM modulation and demodulation process, the use of matlab run)

说明：  根据卫星EIRP值、接收系统G/T值等参数仿真了卫星通信的上下行及总链路预算的matlab程序 及论文《卫星传输链路的计算与应用》(uplink and downlink margin budget)

实现2ASK、2FSK调制及两者的包络检波解调(Implementation of 2ASK, 2FSK modulation and envelope demodulation of both)

AIS信号（GMSK调制）2比特差分解调及其误码率曲线(2 bit differential demodulation and BER)

角谱--VCSEL发出的光，经过透镜耦合进入光纤，仿真给出光由VCSEL进过透镜进入光纤的过程(Angular spectrum)

数据结构（耿国华版）课本源码，课本中的实例程序等。。。(the code of the book.)

这个matlab代码仿真了M-QAM的传输。M的取值不同，调制方式分别为4QAM，16QAM，64QAM等。传输信道为AWGN信道，能出误码率曲线。(The matlab code simulation of the M-QAM transmission. The value of M, the modulation mode of 4QAM, 16QAM, 64QAM. The transmission channel is AWGN, the BER curves.)

MIMO指多输入多输出，MIMO技术大致可以分为两类：发射/接收分集和空间复用。传统的多天线被用来增加分集度从而克服信道衰落，具有相同信息的信号通过不同的路径被发送出去，在接收机端可以获得数据符号多个独立衰落的复制品，从而获得更高的接收可靠性。这种技术往往要结合多天线技术，而多天线技术在移动通信中得到了广泛的研究。(MIMO refers to Multiple Input Multiple Output, MIMO technology can be broadly classified into two categories: transmit/receive diversity and spatial multiplexing. Traditional multi-antenna was used to increase the degree of diversity to overcome channel fading, the signal with the same information through different paths have been sent in the receiver-side data symbols can be multiple independent copies of the decline, which was higher reception reliability. This technology often have to combine multi-antenna technology, and multi-antenna technology in mobile communication has been widely studied.)

说明：  无线衰落信道下的通信仿真，可以更换几种常见的衰落模型，如莱斯衰落，瑞利衰落等(Several common fading models, such as rice fading and Rayleigh fading, can be replaced in the communication simulation of wireless fading channel.)

捷联惯性导航与GPS组合导航。采用matlab实现。采用自适应算法对其进行处理。并取得了很好的效果。(Strapdown inertial navigation and GPS Navigation. Using matlab to achieve. Adaptive algorithm used to deal with them. And has achieved good results.)