power_SM_exciter

hilbert-huang 变换中EMD(经验模态分解)方法对非线性信号的分析，固定模态分量及瞬时频率计算(hilbert-huang transform EMD (Empirical Mode Decomposition) method of nonlinear signal analysis, the fixed component and the instantaneous modal frequency counter Operator)

LYAPACK is a MATLAB toolbox for the solution of certain large scale problems in control theory, which are closely related to Lyapunov equations. In contrast to the lyap and dlyap command in the MATLAB Control toolbox it uses iterative algorithms and is intended for large, sparse problems.

针对双基阵提供的有偏方位角量测信息,对双基阵纯方位目标可观测性的必要条件及其Cramer-Rao下限 进行了理论推导.在此基础上,采用一种新的辅助变量方法对双基阵纯方位跟踪性能进行改进,并在可观测条件下对 目标进行了蒙特卡洛仿真实验.实验结果表明,新的辅助变量方法可以使参数估计精度大大提高,并且上述理论对制 定实际的跟踪策略或算法具有一定的参考价值 (For double-base matrix provided biased information azimuth measurement of double-base bearings-only target array may be a necessary condition for observability and Cramer-Rao lower limit of the theoretical derivation. On this basis, a new auxiliary variable method of double-base bearings-only tracking array to improve performance and can be observed under the condition of targets Monte Carlo simulation. The experimental results show that the new auxiliary variable method can greatly improve the accuracy of parameter estimation and the formulation of the above-mentioned theory tracking the actual strategy or algorithm has certain reference value)

Markov随机场的例子程序,对于初学MRF的人很有用,能得到直观的印象(Markov with airport procedures example, the MRF for a novice who was very useful, can be visual impression)

ldpc编译码包括生成矩阵算法，稀疏矩阵编码，概率译码等等(ldpc encode and encode)

介绍了Matlab下的MPPT扰动观察法仿真中的S函数编写(Introduced under Matlab simulation MPPT perturbation and observation method S-function written)

Matlab code to calculate ArgMin and ArgMax

用该遗传算法程序解决多峰值函数的优化问题，输出结果和图形！(Using the genetic algorithm program to solve the optimization problem of multi-peak function, output and graphics!)

一个基于Simulink的UKF教程,它涵盖了从设计，仿真，硬件在环测试，并建立一个独立的嵌入式系统的开发过程。(Unscented Kalman filtering tutorial: Simulink and tilt sensor case study. It covers the development process from design, simulation, hardware-in-the-loop testing, and creating a stand-alone embedded system. The content is supposed to be as simple/introductory as possible.)

identification nonelinear model single tank with ARX model