Gcv

这是xilinx的FPGA实现各种算数运算的全部基于MATLAB的模型文件，包括加减乘除等(This is the xilinx arithmetic FPGA to achieve the full range of MATLAB-based model of documents, including multiplication and division, such as addition and subtraction)

Constructor Example with class

遗传算法解决tsp问题的MATLAB程序，详细源码。(Genetic algorithms to solve tsp problems MATLAB program, a detailed source.)

说明：  采用离散的方式，实现的永磁同步电机有速度传感器矢量控制，(In a discrete manner, the permanent magnet synchronous motor has a speed sensor vector control,)

TL431提供恒定偏流的电桥 TL431提供恒定偏流的电桥 (TL431 provide a constant bias current of the bridge to provide a constant bias current of the TL431 bridge)

说明：  实现M序列的产生，用于产生M序列，它用在信号的加密，作为训练序列等(Realization of M sequence generation, used to produce M sequence, which used in signal encryption, such as the training sequence)

ribm算法 硬件实现 hardware(ribm algorithm hardware implement)

PSNR峰值信噪比在两个图像上的比较。此程序为一函数。(PSNR comparison of the two images)

在matlab下对认知无线电频谱检测，能量检测，周期循环检测(Under the matlab for cognitive radio spectrum detection and energy detection, cycle detection)

说明：  主要指令：butter（产生巴特沃斯滤波器）；freqz（绘制幅频、相频曲线）；zplane（绘制零、极点图）；ss2zp（状态方程变零、极点）；zp2tf（零、极点变分式多项式）。(Main instruction: butter (produced bart wo filter) Freqz (draw amplitude frequency, phase frequency curve) Zplane (draw zero, poles chart) Ss2zp (state equation is zero, poles) Zp2tf (zero, pole change fraction polynomial). )