Mutation_of_the_PSO

解算图像曲线的函数解析式。给一个图像，最后算出其近似描述葵式子。(The solver function resolution of the image curve type. To an image, and finally calculate the approximate description Kwai formula.)

说明：  Ux profile in boundary layer

this file perform convolutionalencoding

　多输入多输出正交分频多工模拟器。 　　 　　正交分频多工:OFDM模拟器(外层函数) 　　 　　 　　create_channel:产生一个瑞利衰落信道复用,解的天线配置、正交分频多工结构、power-delay档案。 　　 　　 　　svd_decompose_channel:既然全网络知识是假设,在并行传输奇异值模式。这个函数分解这些频道模式。 　　 　　 　　BitLoad:适用bit-loading算法来实现预期的钻头和能量 (MIMO OFDM Simulator: OFDM.m: OFDM Simulator (outer function) create_channel.m: Generates a Rayleigh fading frequency-selective channel, parametrized by the antenna configuration, the OFDM configuration, and the power-delay profile. svd_decompose_channel.m: Since full channel knowledge is assumed, transmission is across parallel singular value modes. This function decomposes the channel into these modes. BitLoad.m: Apply the bit-loading algorithm to achieve the desired bit and energy allocation for the current channel instance. ComputeSNR.m: Given the subcarrier gains, this simple function generates the SNR values of each channel (each singular value on each tone is a separate channel). chow_algo.m: Apply Chow s algorithm to generate a particular bit and energy allocation. EnergyTableInit.m: Given the SNR values, form a table of energy increments for each channel. campello_algo.m: Apply Campello s algorithm to converge to the optimal bit and energy allocatio)

卡尔曼滤波，具有自适应功能,对应五个经典的公式，方便大家学习使用(Kalman filter, the adaptive function Corresponding to the five classic formula, facilitate everybody to learn to use )

its help ful for learning adaptive filter I hope that you have good learning adaptive filter

一个雷达检测运动目标的仿真程序源代码,与同行共享(A radar simulation program source code for moving target detection)

MATLAB软件对b样条曲线曲面进行拟合(B-spline curve and surface fitting)

说明：  EMD分解matlab小程序，里面包含有EMD工具箱，非常的好用。(EMD decomposes a small matlab program, which contains an EMD toolbox, which is very easy to use.)

Corner detection for camera calibration using a 3D calibration object. To get corners one must to define a 6point ROI. The corners will be detected inside ROI and will be put into a vector.