psd_my

说明：  三相电压源型PWM整流器，采用了电压电流双闭环的控制策略(The three-phase voltage source PWM rectifier )

结构分析的有限元法与matlab程序设计3-2(Structural analysis of the finite element method and matlab programming 3-2)

基于粒子群算法的图像分割算法代码源程序，主要是基于阈值分割的方法的(Image segmentation algorithm based on particle swarm optimization (pso) algorithm)

In order to minimize power losses caused by high current and improve the voltage profile in the network distribution, the introduction of dispersed generations also called productions decentralized in distribution network (DG) plays an important role. The installation of DGs directly affects the power requested or purchased. The sizing and placement of DGs in the system must be optimal because a wrong choice has a negative impact on the system behavior. To solve this combinatorial problem, an algorithm known as Firefly algorithm is proposed in this paper. This is a meta-heuristic algorithm inspired by the behavior of fireflies flashing. The main objective of firefly flash is to act as a signaling system to attract other fireflies. Networks tested IEEE69-bus and IEEE33-bus are used to evaluate the effectiveness of this method. The results are compared with those obtained by genetic algorithm (GA) to IEEE69-bus, and Shuffled frog leaping algorithm (SFLA) for IEEE 33-bus.

The book describes a variety of optimization problems: unconstrained, constrained, gradient, and nongradient techniques duality concepts multiobjective optimization linear, integer, geometric, and dynamic programming with applications and finite element–based optimization

以下在matlab中利用图像处理工具箱实现均方误差（MSE）、峰值信噪比（PSNR）和熵的源代码 (The following use in matlab image processing toolbox mean square error (MSE), the peak signal to noise ratio (PSNR), and entropy source code)

说明：  可以与carsim联合仿真模拟车辆轨迹跟踪(It can be used with CarSim to simulate vehicle trajectory tracking)

用于图像的主成分变换，完成数据压缩的目的和数据信息的提取(transformation of features)

LDPC译码仿真实验 程序代码 simulingk仿真(LDPC decoder simulation simulation code simulingk)

说明：  matlab 与VC混合编程，通过MATLAB调用MATLAB的函数的WORD文档，按上面的例子，一步一步，就可以实现。(mixed programming with VC matlab, MATLAB by calling the function MATLAB WORD document, according to the example above, step by step, can be achieved.)