登录
首页 » matlab » generating-random-Numbers

generating-random-Numbers

于 2011-04-19 发布 文件大小:154KB
0 240
下载积分: 1 下载次数: 15

代码说明:

  产生随机数的方法很多,很多软件自己就有产生随机数函数,本程序用的是乘同余法产生随机数,经对比,效果比matlab自带的要好。(Many methods of generating random Numbers, this procedure is by using congruence method generating random Numbers.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • doc8003
    Atmel抯 AVR controller offers an Analog to Digital Converter with 10-bit resolution. In most cases 10-bit resolution is sufficient, but in some cases higher accuracy is desired. Special signal processing techniques can be used to improve the resolution of the measurement. By using a method called 慜versampling and Decimation?higher resolution might be achieved, without using an external ADC. This Application Note explains the method, and which conditions need to be fulfilled to make this method work properly
    2012-05-27 18:23:06下载
    积分:1
  • neighborhood-classifier
    neighborhood classifierneighborhood classifier
    2011-09-03 21:07:42下载
    积分:1
  • matlab_rgb_gray
    MATLAB程序 根据RGB图像创建一幅灰度图像(MATLAB program to create a gray scale image according to RGB image)
    2010-07-27 19:34:53下载
    积分:1
  • matlabyuanchengxu
    说明:  遗传算法解决无功优化问题,比较全面的程序提供共享(Genetic algorithm to solve reactive power optimization problem, a more comprehensive program to provide shared)
    2011-04-17 17:06:43下载
    积分:1
  • PFCBoost
    介绍了平均电流控制型 PFC Boost 变换器的结构, 分析了其工作原理。 分别采用 Power System 工具箱和考虑电感电流断续工作状态的 C-MEX 文件 S 函数建立了主电路模型,对平均电 流控制型 PFC Boost 变换器进行了仿真。仿真结果表明,与 Power System 工具箱模型相比,基于 C-MEX 文件的 S 函数仿真模型能够准确仿真电流断续工作状态,仿真速度快。设计了电路样机进 行了实验研究,仿真结果与实验结果一致,证明了该方法的正确性。利用该方法可以高效地仿真 研究系统结构和参数变化时性能变化情况,得到的平均电流控制型 PFC Boost 变换器的混沌分岔 图,为更好地理解和设计这种变换器提供了有利的工具。(The structure of average current controlled power factor correction (PFC) Boost converter is introduced, and its working principle is analyzed. The PFC Boost converter is simulated using the model established with Power System toolbox and the C-MEX file S-function model respectively. Simulation results show that the C-MEX file S-function model can simulate the all state of the converter including discontinuous conduction mode with high speed. Experimental results show the correctness of the simulation results and the proposed method. The method is suitable for simulation the performance changing with the variation of system structure or parameters. The bifurcation diagram is derived for PFC Boost converter using this method, which is very useful for better understanding and better design of the converter.)
    2015-01-21 19:19:29下载
    积分:1
  • MATLAB
    针对一组数据的分类方法,在matlab中实现,从中可以观察到数据之间的联系(For a set of data classification method, implemented in matlab can be observed from the data to the link between)
    2013-04-22 22:11:03下载
    积分:1
  • ms123
    matlab code for msr in gray scale
    2013-05-07 14:29:56下载
    积分:1
  • Bayliss
    自己编写的一线性差波束MATLAB程序,波束综合程序(pattern synthesis program by myself)
    2020-11-22 10:39:35下载
    积分:1
  • power_SwitchedReluctanceMotor
    This document is about power switched reluctance motor.
    2014-08-10 13:56:50下载
    积分:1
  • EMD081116
    经验模态分解的matlab源程序,手工编写样条插值方法(Empirical mode decomposition matlab source, manual preparation of spline interpolation method)
    2009-12-13 11:16:17下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载