STREETFIGHTERIVsave

说明：  模糊控制matlab，倒立摆，应该会有用(Fuzzy control matlab, inverted pendulum, should be used)

该程序采用MATLAB软件编写，能够很好的实现快速傅里叶的频谱分析。(The program using MATLAB writing software, can achieve a good FFT spectrum analysis. )

MATLAB SIMULINK SIMITH 控制模型(MATLAB SIMULINK SIMITH control model)

说明：  单相桥式整流电路闭环相控调压，simulink中搭建单相桥式整流电路，利用PI控制方式，实现输出电压的相控(The single-phase bridge rectifier circuit is closed-loop phase controlled voltage regulation, the single-phase bridge rectifier circuit is built in Simulink, and the PI control mode is used to realize the phase control of output voltage)

说明：  免疫算法和遗传算法的结合，非常不错，希望对大家有用。(Immune algorithm and genetic algorithm combination, very good, and I hope useful.)

本程序实现多模态故障检测与故障诊断，用的方法是PCA_GMM，GMM是用的FJ算法，效果很好(This procedure realize multimodal, fault detection and fault diagnosis method is PCA_GMM, GMM FJ algorithm is used, the effect is very good)

of the electrical power system. At the time of transformer energization high current is drawn by the transformer known as the inrush current. This current is nearly ten times more than the full load current of transformer. It produces mechanical stress on transformer and also affects the windings and bushings of the transformer. The large switching transient current affects malfunction of protection system of power system and the different equipments connected to system. So the inrush current should be minimized. There are different methods used to minimize the inrush current such as volt second balance, series compensator, point on wave switching method etc. This paper focuses on point on wave switching method. It also explains the results for inrush current of three phase transformer with and without point on wave switching method. A test is driven on 450 kVA, 500kV/230kV grounded Y/D transformer in MATLAB/SIMLINK environment. It also focuses on

PS-InSAR处理软件，StaMPS的最新版本v3.3b1(PS-InSAR processing software, the latest edition of m v3.3)

数字AGC自动增益控制电路MATLAB仿真与实现(read Chinese above)

Parallel active power filter