matlabdaima

说明：  本程序用于实现求解并绘制正弦信号功率谱密度的功能(procedures used to achieve the solution and the mapping of sinusoidal signal power spectral density function)

实现dijstra算法，算出任意两点间的最短路径(Implementing Dijstra algorithms)

关于小波分析的matlab程序，大家可以参考一下~(On wavelet analysis matlab program, we can refer to)

说明：  fuzzy logic and we have fuzzy logic control to engginer

该程序用于计算n根平行导线间的串扰,程序结构及说明见程序内。源可以是单频的或脉冲的（这里给出的是频域的）。频率、波形、线长、电源及负载阻抗均可在用MATLAB编写的语句中方便地修改。但必须输入导线系统每单位长度的电感、电容矩阵。(The procedure used to calculate n root of crosstalk between parallel wires, program structure and description of process. Source can be single frequency or pulse (here is given by the frequency domain). Frequency, waveform, the line is long, power and load impedance can be found in the use of MATLAB statements prepared easily modified. However, the system must enter a wire per unit length inductance, capacitance matrix.)

说明：  matlab编程，用于计算电力系统短路潮流，源代码提供在这里，希望供大家参考(Matlab programming used in the calculation of the power system short-circuit the trend, the source code available here, for your reference)

说明：  检点检测，经测试可用，环境为matlab(harris detecter based on matlab)

说明：  数字滤波器,仿真成功为低通滤波器.一个典型的滤波器的仿真 比较详细 还有图(digital filters, the success of the simulation low-pass filter. A typical simulation of the filter there are also more detailed)

We present in this paper a new method for blind source separation which is adapted to the case where the sources have different morphologies. We show that the morphology diversity concept leads to a new and very efficient method, even in the presence of noise.

说明：  一个duffing模型，一个噪声模型，一篇duffing检测原理，。可检测不同频率的待测信号(a duffing model, a noise model, a duffing detection principle)